2008 Toyota Aygo

Front Inner Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security both side seal (6.2.2 (d) (i))

Rear Coil spring corroded both side (5.3.1 (b) (i))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Front Outer Exhaust has a major leak of exhaust gases (6.1.2 (a))

Front Outer Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting both side (6.2.2 (d) (i))

Offside Rear Parking (secondary brake) on a single line braking system grabbing severely (1.3.1 (c))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Rear Inner Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting both side seal (6.2.2 (d) (i))

Front Inner Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security both side seal (6.2.2 (d) (i))

Rear Coil spring corroded both side (5.3.1 (b) (i))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Exhaust mounting defective (6.1.2 (a))

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Headlamp lens slightly defective (4.1.1 (b) (i))

Inner Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced and outer sills both sides (6.1.1 (c) (i))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Offside Front Direction indicator not working (4.4.1 (a) (ii))

Rear Subframe mounting prescribed area excessively corroded significantly reducing structural strength both sides (5.3.6 (a) (i))

Exhaust mounting defective (6.1.2 (a))

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Headlamp lens slightly defective (4.1.1 (b) (i))

Nearside Front Direction indicator not working (4.4.1 (a) (ii))

Nearside Headlamp lens seriously defective (4.1.1 (b) (ii))

Nearside Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced floor to sill (6.1.1 (c) (i))

Nearside Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced outer sill (6.1.1 (c) (i))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Nearside Rear Subframe mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced floor to sill (6.1.1 (c) (i))

Offside Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced outer sill (6.1.1 (c) (i))

Offside Rear Subframe mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Exhaust mounting defective (6.1.2 (a))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement both (5.3.4 (a) (i))

Front Lower Suspension arm pin or bush worn but not resulting in excessive movement both (5.3.4 (a) (i))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Vehicle structure is corroded but structural rigidity is not significantly reduced sills both sides (6.1.1 (c) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Brake pipe corroded, covered in grease or other material Both rear brake pipes corroded (1.1.11 (c))

Offside Rear Outer Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting Sill corrosion (6.2.2 (d) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Brake pipe corroded, covered in grease or other material Both rear brake pipes corroded (1.1.11 (c))

protective underseal applied

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Suspension component mounting prescribed area excessively corroded significantly reducing structural strength both rear axle mountings holed and corroded (5.3.6 (a) (i))

Suspension component mounting prescribed area excessively corroded significantly reducing structural strength nearside rear axle mount holed and corroded (rear of sill) (5.3.6 (a) (i))

Suspension component mounting prescribed area excessively corroded significantly reducing structural strength offside rear axle mount (rear inner sill holed and corroded) (5.3.6 (a) (i))

Central Stop lamp(s) with a multiple light source up to 1/2 not functioning (4.3.1 (a) (i))

Nearside Front Road wheel slightly distorted (5.2.2 (c) (i))

Nearside Rear Road wheel slightly distorted (5.2.2 (c) (i))

Offside Rear Brake pipe corroded, covered in grease or other material slight corrosion (1.1.11 (c))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

front exhaust mount corroded away

front subframe heavily corroded

Extensive surface corrosion to front and rear sub frames

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Extensive surface corrosion to front and rear sub frames

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Front exhaust bracket broken

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Headlamp aim too high (1.8)

Nearside Rear Tyre has a tear, caused by separation or partial failure of its structure (4.1.D.1b)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Headlamp aim too high (1.8)

Offside Rear Outer Suspension component mounting prescribed area is excessively corroded sill (2.4.A.3)

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Registration plate lamp not working (1.1.C.1d)

Front exhaust bracket broken

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Items removed from driver's view prior to test

o/s/r tyre starting to crack

Exhaust system not adequately supported (7.1.1)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Windscreen washer provides insufficient washer liquid (8.2.3)

Items removed from driver's view prior to test

o/s/r tyre starting to crack

Front Tyre worn close to the legal limit (4.1.E.1)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Front Tyre worn close to the legal limit (4.1.E.1)