2012 Mazda 6

Emissions unable to be completed Engine noise (8.2.2.2 (e))

Front Brake disc significantly and obviously worn (1.1.14 (a) (i))

Nearside Front Lower Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Front Upper Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Upper Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Windscreen damaged and affecting the driver's view of the road (3.2 (a) (ii))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Offside Front Lower Suspension arm ball joint likely to become detached (5.3.4 (a) (ii)) DANGEROUS

Offside Front Wheel bearing play so excessive it is likely to break up (5.1.3 (a) (ii)) DANGEROUS

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Power steering inoperative and steering adversely affected (2.1.5 (c) (ii)) DANGEROUS

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Rear Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Suspension arm corroded but not seriously weakened Both sides (5.3.3 (b) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Front Tyre worn close to legal limit/worn on edge both (5.2.3 (e))

Offside Front Suspension arm ball joint has slight play (5.3.4 (a) (i))

Windscreen wiper does not clear the windscreen effectively (8.2.2)

covers fitted

Offside Front front brake excessively fluctuating (3.7.B.3)

Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone 'A' dash cam/air freshner (8.3.1e)

Nearside Rear tyre on limit/worn outer edge

Nearside front brake fluctuating, but not excessively (3.7.B.3)

Offside Front tyre low/worn inner edge

Offside Rear tyre very low/nail in tread

covers fitted

Nearside Front Tyre worn close to the legal limit (4.1.E.1)