2002 Toyota Corolla

Nearside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside front brake binding (3.7.B.1)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside Headlamp aim too low and too far to the right. (1.8)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside front brake binding (3.7.B.1)

Parking brake lever has no reserve travel (3.1.6b)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Brake pipe inadequately supported (3.6.B.1)

Registration plate lamp not illuminating the registration plate nsr dim. (1.1.C.1e)

Seat belt anchorage prescribed area is excessively corroded os and ns front lower (5.2.6)

Sub-frame corroded and seriously weakened (2.4.G.1)

Suspension component mounting prescribed area is excessively corroded ns and os front lower (2.4.A.3)

Suspension component mounting prescribed area is excessively corroded ns and os front upper (2.4.A.3)

Suspension component mounting prescribed area is excessively corroded os and ns rear lower (2.4.A.3)

Windscreen washer provides insufficient washer liquid (8.2.3)

Windscreen wiper does not clear the windscreen effectively (8.2.2)

aux drive belt deteriorated.

brake servo has slow and low assistance but passes inspection requirements.

excessive corrosion out of PA to os and ns rear body.

heavy surface corrosion inside and outside of PA's

nsf anti roll bar link has minor play

nsf seat belt minor deterioration.

nsf steering has minor play.

rear axle bushes have visual deterioration but no excessive play.

rear shock / spring seats corroded.

this vehicle is extensivley corroded to both body and components.

under guards and covers fitted to inner arches and sils.

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Front coil spring corroded (2.4.C.1b)

Manufacture outer sill covers fitted

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

underside of vehicle under sealed

Battery insecure (1.9.1)

Nearside Front Macpherson strut has excessive movement in the upper support bearing assembly (2.5.B.1b)

Nearside Front Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Suspension component mounting prescribed area is excessively corroded near axle mount (2.4.A.3)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Seat belt anchorage prescribed area is excessively corroded sill (5.2.6)

Offside Front Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded near axle mount (2.4.A.3)

Offside Seat belt anchorage prescribed area is excessively corroded floor pan (5.2.6)

Offside Seat belt anchorage prescribed area is excessively corroded sill (5.2.6)

Parking brake: efficiency below requirements (3.7.B.7)

Windscreen washer provides insufficient washer liquid (8.2.3)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Front coil spring corroded (2.4.C.1b)

Offside Front Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

manufacture outer sill covers fitted

front crossmember damaged

heavy amount of underseal on floorpans and inner sills

o/s+n/s rear inner front wheel arches corroding

Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Front Electrical wiring inadequately supported (1.9.2a)

Nearside Front Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Inner Front Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Inner Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Inner Seat belt anchorage prescribed area is inadequately repaired (5.2.6)

Nearside Side repeater incorrect colour (1.4.A.2f)

Offside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Inner Front Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Inner Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Inner Seat belt anchorage prescribed area is inadequately repaired (5.2.6)

Offside Rear Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Rear Stop lamp not working (1.2.1b)

Offside Rear Tyre not fitted in accordance with side wall instructions (4.1.D.1f)

Offside Side repeater incorrect colour (1.4.A.2f)

front crossmember damaged

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

front crossmember is bent and twisted by an accident and been repaired but is not insecure.

Nearside Front Battery insecure (1.9.1)

Nearside Rear Brake hose excessively deteriorated (3.6.B.4d)

Nearside Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Rear Brake hose excessively deteriorated (3.6.B.4d)

Offside Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Rear Registration plate lamp not working (1.1.C.1d)

front brake binding (3.7.B.1)

rear brake binding (3.7.B.1)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

front crossmember is bent and twisted by an accident and been repaired but is not insecure.

Rear Brake pipe slightly corroded (3.6.B.2c)

Front Brake pad(s) wearing thin (3.5.1g)

Front brake disc slightly pitted (3.5.1h)

Nearside Front Shock absorber has slight corrosion to the casing (2.7.2a)

Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Front Front suspension has excessive play in a upper suspension ball joint (2.5.B.1a)

Nearside Registration plate lamp not working (1.1.5c)

Offside Front Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Offside Headlamp not working on dipped beam (1.7.5a)

Front Brake pad(s) wearing thin (3.5.1g)

Front brake disc slightly pitted (3.5.1h)

Nearside Front Shock absorber has slight corrosion to the casing (2.7.2a)

Front Brake pad(s) wearing thin (3.5.1g)