2007 Mazda 6

Nearside Front Inner Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Lower Suspension arm ball joint dust cover severely deteriorated both ball joint gators covered in sealer (5.3.4 (b) (i))

Offside Front Inner Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Lower Suspension arm ball joint dust cover severely deteriorated both ball joint gators covered in sealer (5.3.4 (b) (i))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive strut turret small hole covered in underseal (5.3.6 (a) (i))

front and rear sub frames covered in underseal

Offside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced footwell within seat belt anchor and suspension 30CM rule (7.1.1 (a) (i))

Nearside Front Inner Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Lower Suspension arm ball joint dust cover severely deteriorated both ball joint gators covered in sealer (5.3.4 (b) (i))

Offside Front Inner Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Lower Suspension arm ball joint dust cover severely deteriorated both ball joint gators covered in sealer (5.3.4 (b) (i))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive strut turret small hole covered in underseal (5.3.6 (a) (i))

front and rear sub frames covered in underseal

Rear Brake pipe corroded, covered in grease or other material both sides at flex pipe (1.1.11 (c))

general underbody corrosion and suspension componets but all satisfactory at time of test

Nearside Front Inner Brake pipe likely to become detached or damaged flex pipe at strut (1.1.11 (d) (ii))

Rear Brake pipe corroded, covered in grease or other material both sides at flex pipe (1.1.11 (c))

general underbody corrosion and suspension componets but all satisfactory at time of test

Offside Front Outer Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii))

all four ball joint boots perishing

rear trailing arm bushes spliting

Front Lower Suspension arm ball joint dust cover damaged, but preventing the ingress of dirt both sides all 4 gaitors (2.4.G.2)

Rear Brake pipe slightly corroded to both rear flex pipes (3.6.B.2c)

Rear Lower Trailing arm corroded but not seriously weakened both sides and rear sub frame and front sub frame (2.4.G.1)

Front Headlamp aim too high both sides (1.8)

Front Lower Suspension arm ball joint dust cover damaged, but preventing the ingress of dirt both sides all 4 gaitors (2.4.G.2)

Rear Brake pipe slightly corroded to both rear flex pipes (3.6.B.2c)

Rear Lower Trailing arm corroded but not seriously weakened both sides and rear sub frame and front sub frame (2.4.G.1)

Nearside Front Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Rear Exhaust system not adequately supported (7.1.1)

Nearside Front Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

advise boot tested as presented

Nearside Front coil spring broken (2.4.C.1a)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

advise boot tested as presented

Vehicle's internal headlight adjuster altered to recheck lights

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

advise exhaust y pipe support bracket corroded off b ut still adiquitly supperted

Offside Front Headlamp aim too low (1.8)

Vehicle's internal headlight adjuster altered to recheck lights

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

advise exhaust y pipe support bracket corroded off b ut still adiquitly supperted

Nearside Rear Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Offside front brake juddering slightly (3.7.A.2b)