2006 Kia Sportage

Rear Suspension component mounting repair covered in underseal nearside & offside, inner & outer sills (5.3.6 (a) (i))

Front Exhaust has a major leak of exhaust gases (6.1.2 (a))

Rear Suspension component mounting repair covered in underseal nearside & offside, inner & outer sills (5.3.6 (a) (i))

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Rear Suspension component mounting prescribed area damaged but not considered excessive inner and outer sills (5.3.6 (a) (i))

Offside Rear Suspension component mounting repair covered in underseal (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive inner sill (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive inner sill (5.3.6 (a) (i))

Offside Rear Suspension component mounting repair covered in underseal (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive inner sill (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive inner sill (5.3.6 (a) (i))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive Trailing Arm (5.3.6 (a) (i))

Offside Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive Trailing Arm (5.3.6 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Brake performance not tested Due To Brake Fluid Leak (1.2.1 (g))

Brake pipe leaking on a hydraulic braking system Front To Rear (1.1.11 (b) (ii)) DANGEROUS

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive Trailing Arm (5.3.6 (a) (i))

Offside Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive Trailing Arm (5.3.6 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Electronic stability control warning lamp indicates a fault (7.12 (e))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Front Lower Suspension arm corroded and seriously weakened (5.3.3 (b) (i))

Offside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Under-trays fitted obscuring some underside components

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Outer Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Front Lower Suspension arm rubber bush bonding deteriorated resulting in excessive movement (2.4.G.2)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Rear Exhaust system not adequately supported (7.1.1)

Child seat fitted not allowing full inspection of adult belt

Spare tyre defective

Under-trays fitted obscuring some underside components

oil level low

Power steering component(s) has slight seepage from a component (2.3.3b)

both rear tyres close to 1.6 mm

Front Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Front Lower Suspension arm ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Inner Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Power steering component(s) has slight seepage from a component (2.3.3b)

bonnet safety catch sticking

both rear tyres close to 1.6 mm

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Oil leak

bonnet safety catch sticking

exhaust front flexible section slightly deteriorated

exhaust front mounting clamp deteriorated but still secure at time of test

inner surface of nearside rear brake disc rusty

Nearside Front Upper Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Front Lower Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Child seat fitted not allowing full inspection of adult belt

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Oil leak

bonnet safety catch sticking

exhaust front flexible section slightly deteriorated

exhaust front mounting clamp deteriorated but still secure at time of test

inner surface of nearside rear brake disc rusty

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Nearside Registration plate lamp not working (1.1.C.1d)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

both rear tyres wearing on edges

Nearside Headlamp aim too high (1.8)

both rear tyres wearing on edges