2007 Subaru Forester

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

Nearside Rear Anti-roll bar ball joint has slight play (5.3.4 (a) (i))

Offside Front Anti-roll bar ball joint has slight play (5.3.4 (a) (i))

Offside Rear Anti-roll bar ball joint has slight play (5.3.4 (a) (i))

Offside Rear Service brake grabbing slightly (1.2.1 (c))

Front Headlamp aim too low (4.1.2 (a))

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

Nearside Rear Anti-roll bar ball joint has slight play (5.3.4 (a) (i))

Offside Front Anti-roll bar ball joint has slight play (5.3.4 (a) (i))

Offside Rear Anti-roll bar ball joint has slight play (5.3.4 (a) (i))

Offside Rear Service brake grabbing slightly (1.2.1 (c))

Nearside Headlamp aim projected beam image is obviously incorrect Headlight has water ingress and has been drilled for drainage (4.1.2 (c))

Offside Rear Service brake excessively binding (1.2.1 (f))

Front Headlamp has a product on the lens but not seriously reducing light output both (4.1.4 (b))

Rear Lower underseal

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

surface corrosion to rear subframe

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Offside Rear Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Rear Anti-roll bar corroded but not seriously weakened (5.3.3 (b) (i))

Rear Coil spring corroded (5.3.1 (b) (i))

Rear underbody surface corrosion

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Offside Front Headlamp has a product on the lens so that the light output is severely reduced (4.1.4 (b))

Offside Rear Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Rear Anti-roll bar corroded but not seriously weakened (5.3.3 (b) (i))

Rear Coil spring corroded (5.3.1 (b) (i))

Rear underbody surface corrosion

Nearside Rear Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting marked in yellow (6.2.2 (d) (i))

Offside Rear Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting marked in yellow (6.2.2 (d) (i))

Nearside Rear Axle swivel pins and bushes swivel pin and/or bush slightly worn (5.1.2 (b) (i))

Offside Rear Axle swivel pins and bushes swivel pin and/or bush slightly worn (5.1.2 (b) (i))

Offside Rear Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Rear Anti-roll bar corroded but not seriously weakened (5.3.3 (b) (i))

Rear underbody surface corrosion

Central Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Front Headlamp lens slightly defective (4.1.1 (b) (i))

Nearside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Nearside Headlamp lens slightly defective (4.1.1 (b) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Anti-roll bar ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Rear Shock absorbers has a serious fluid leak (5.3.2 (b))

Offside Rear Shock absorbers has a serious fluid leak (5.3.2 (b))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Headlamp aim too high both (4.1.2 (a))

both front tyres worn on inner edges

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)