2009 Honda CBF125

Front Brake binding but not excessively (1.2.1 (f))

Front Brake indicates slight fluctuation of brake effort (1.2.1 (e))

Rear Brake indicates slight fluctuation of brake effort (1.2.1 (e))

Rear Brake effort inadequate at a wheel (1.2.1 (a) (i))

Rear Brake indicates excessive fluctuation of brake effort (1.2.1 (e))

Rear Brake pedal has insufficient reserve travel (1.1.2 (a))

Rear Rear reflector missing (4.8.2 (a) (ii))

Steering operation fouling on the fuel tank or bodywork on full lock (2.1.4 (b))

Front Brake binding but not excessively (1.2.1 (f))

Front Brake indicates slight fluctuation of brake effort (1.2.1 (e))

Nearside Front Footrest slightly loose (6.2.12 (a))

rear body work insecure not likely to fall off

Front Brake pad(s) close to minimum limit (1.1.13 (a))

centre stand not fit for purpose

Central Rear Registration plate does not conform to the specified requirements rear number plate has corner missing so missing letter border. (0.1 (d))

Nearside Rear Direction indicator not working (4.4.1 (a) (ii))

Nearside Rear Drive chain excessively tight Chain seized and too tight. (6.1.7 (k) (i))

Offside Front Shock absorber has a serious fluid leak front suspension has reduced dampening effect. (5.3.2 (b))

Central Centre stand not fit for purpose. Foot rest part missing.

Central Front Tyre under inflated.

Central Rear Brake indicates slight fluctuation of brake effort (1.2.1 (e))

Central Rear Tyre under inflated.

Nearside Rear Rear sprocket rubber drive worn. Sprocket has movement.

Nearside Side stand stiff in operation.

Offside Rear brake pedal has slightly too much movement before rear brake comes on.

Drive chain slightly loose (6.1.7 (c) (i))

swing arm slightly corroded

Front Floor brake test indicates a binding brake (3.3.C2c)

Front Front position lamp does not illuminate immediately when switched on (1.1.3a)

Front Exhaust is leaking and excessively noisey (7.1.1b)

Rear Drive chain sprocket carrier worn to excess (6.2.1e)

Rear Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))