2012 Mazda 6

Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

vehicle structure is corroded but structural rigidity is not significantly reduced.

Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Brake pedal has insufficient reserve travel (1.1.2 (a))

Electronic stability control warning lamp indicates a fault (7.12 (e))

Nearside Rear Service brake effort inadequate at a wheel (1.2.1 (a) (i))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Front Service brake effort inadequate at a wheel (1.2.1 (a) (i))

Offside Rear Brake hose excessively chafed also twisted (1.1.12 (b) (ii))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

Brake hydraulic reservoir fluid not visible (1.1.10 (d) (iii)) DANGEROUS

Front Brakes imbalanced across an axle by more than 50% Axle 1 (1.2.1 (b) (ii)) DANGEROUS

Brake fluid warning lamp illuminated (1.1.10 (f))

Exhaust heat shield loose

Nearside Front wheel bearing has excessive play (2.5.A.3c)

Nearside Front wheel bearing rough when rotated (2.5.A.2)

Offside Front Front wheel bearing has excessive play (2.5.A.3c)

Offside Front wheel bearing has excessive play (2.5.A.3c)

Offside Front wheel bearing rough when rotated (2.5.A.2)

Parking brake: efficiency below requirements (3.7.B.7)

rear brake application uneven (3.7.B.2)

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Brake pad(s) wearing thin (3.5.1g)

Nearside Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Front Brake pad(s) wearing thin (3.5.1g)

Offside Rear Brake pad(s) wearing thin (3.5.1g)

Offside Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)