2002 Subaru Forester

Nearside Front Suspension component ball joint excessively worn (5.3.4 (a) (i))

Offside Front Suspension component ball joint excessively worn (5.3.4 (a) (i))

Offside Registration plate lamp does not illuminate simultaneously with the position lamps (4.7.2 (a))

Rear Exhaust system insecure (6.1.2 (a))

Stop lamp(s) not working Nearside and Offside (4.3.1 (a) (ii))

Windscreen washer provides insufficient washer liquid (3.5 (a))

Nearside Suspension spring mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected Inner Sill, Jacking Point, Rear Axle Mounting Area (5.3.6 (a) (ii)) DANGEROUS

Nearside Front Headlamp lens slightly defective (4.1.1 (b) (i))

Nearside Front Tyre slightly damaged/cracking or perishing Cracking Inner and Outer Edge/s (5.2.3 (d) (i))

Offside Front Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Front Tyre slightly damaged/cracking or perishing Cracking Inner and Outer Edge/s (5.2.3 (d) (i))

Offside Rear Brake hose slightly chafed (1.1.12 (b) (i))

Windscreen damaged but not adversely affecting driver's view Stone Chip/s 'A' Zone (3.2 (a) (i))

All brake pipes greased

Offside Front Play in steering rack inner joint(s) ()

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Headlamp aim too low (1.8)

Nearside Rear Suspension component mounting prescribed area is excessively corroded Suspension arm front mounting (2.4.A.3)

Offside Front Brake pipe excessively corroded (3.6.B.2c)

Offside Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Offside Headlamp aim too low (1.8)

Offside Rear Suspension component mounting prescribed area is excessively corroded Suspension arm front mounting (2.4.A.3)

Offside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Offside front brake excessively fluctuating (3.7.B.3)

Rear wheel bearing rough when rotated (2.6.1)

Windscreen washer provides insufficient washer liquid (8.2.3)

front brake application uneven (3.7.B.2)

Nearside Front Suspension component mounting prescribed area is excessively corroded Lower arm mouting (2.4.A.3) DANGEROUS

Body has slight corrosion (6.1.B.2)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Nearside Inner Front Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Inner Front Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

engine management light on

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Front Anti-roll bar attachment bracket/mounting fractured (2.4.G.1)

Nearside Front Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Front coil spring broken (2.4.C.1a)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Headlamp aim too low (1.8)

Nearside Inner Front Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Headlamp aim too low (1.8)

Offside Inner Front Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

engine management light on

Front Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Brake pad(s) wearing thin (3.5.1g)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

both front tyres inner edges badly worn

engine management light on

nearside rear disc poor condition (corrosion)

nearside rear tyre poor condition (perished and cracked)

Brake pipe excessively corroded (3.6.B.2c)

Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Rear Anti-roll bar fractured (2.4.G.1)

Front Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Brake pad(s) wearing thin (3.5.1g)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

both front tyres inner edges badly worn

engine management light on

nearside rear disc poor condition (corrosion)

nearside rear tyre poor condition (perished and cracked)

Engine management light on

Front Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust has a major leak of exhaust gases (7.1.2)

Front registration plate delaminated (6.3.1d)

Engine management light on

Front Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Front Brake pad(s) wearing thin (3.5.1g)

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust has a major leak of exhaust gases (7.1.2)

Offside Front Anti-roll bar linkage ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Front Steering system excessively tight (2.2.D.1)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Rear Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

engine management light on

Brake pipe slightly corroded (3.6.B.2c)

Exhaust has a minor leak of exhaust gases (7.1.2)

Steering system slightly tight (2.2.D.1)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Exhaust has a major leak of exhaust gases (7.1.2)

Exhaust has part of the system excessively deteriorated (7.1.1a)

Offside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Brake pipe slightly corroded (3.6.B.2c)

Exhaust has a minor leak of exhaust gases (7.1.2)

Steering system slightly tight (2.2.D.1)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Nearside front brake binding (3.7.B.1)

Front Brake pad(s) wearing thin (3.5.1g)

Rear Brake pad(s) wearing thin (3.5.1g)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Exhaust system not adequately supported (7.1.1)

Nearside Brake pipe excessively corroded (3.6.B.2c)

Nearside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Service brake juddering severely (3.7.C.2)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Rear registration plate deteriorated (6.3.1d)

Nearside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Brake lining(s) less than 1.5 mm thick (3.5.1g)

Offside Front Brake lining(s) less than 1.5 mm thick (3.5.1g)