2006 Toyota Aygo

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Exhaust has a minor leak of exhaust gases back box (6.1.2 (a))

slight corrosion of both rear inner and outer sills

Nearside Rear Wheel bearing rough when rotated (5.1.3 (b) (i))

Exhaust has a minor leak of exhaust gases back box (6.1.2 (a))

slight corrosion of both rear inner and outer sills

Nearside Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Headlamp lens slightly defective (4.1.1 (b) (i))

slight corrosion both rear inner and outer sills

Offside Rear Position lamp not working (4.2.1 (a) (ii))

Offside Rear Shock absorbers has a serious fluid leak (5.3.2 (b))

Nearside Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Headlamp lens slightly defective (4.1.1 (b) (i))

slight corrosion both rear inner and outer sills

advise slight corrosion inner and outer sills

Hazard warning switch inoperative (4.4.2 (a) (ii))

advise slight corrosion inner and outer sills

advise underside of vehicle and brake and suspension components slight corrosion

Front Exhaust has a major leak of exhaust gases manifold (6.1.2 (a))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Front Seat belt anchorage prescribed area strength or continuity significantly reduced inner sill/floor (7.1.1 (a) (i))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Rear Exhaust silencer insecure (8.1.1 (b) (i))

advise underside of vehicle and brake and suspension components slight corrosion

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Exhaust has a minor leak of exhaust gases exhaust manifold (6.1.2 (a))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

advise general corrosion of underside of vehicle ands suspension components

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Offside Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Front Exhaust mounting defective (6.1.2 (a))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Front Headlamp aim so that beam "kick up" is not visible on the screen (4.1.2 (a))

Offside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Front Suspension arm pin or bush likely to become detached (5.3.4 (a) (ii)) DANGEROUS

Front Exhaust mounting defective (6.1.2 (a))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Front Sub-frame corroded but not seriously weakened (2.4.G.1)

Front tyres worn on inner edges

Nearside Front Macpherson strut corroded but not seriously weakened (2.4.G.1)

Nearside Front has slight damage to outer sidewall

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement rear bush (2.4.G.2)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Front Sub-frame corroded but not seriously weakened (2.4.G.1)

Nearside Front Macpherson strut corroded but not seriously weakened (2.4.G.1)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Macpherson strut corroded but not seriously weakened (2.4.G.1)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Suspension arm rubber bush bonding deteriorated resulting in excessive movement rear bush (2.4.G.2)

Front Sub-frame corroded but not seriously weakened (2.4.G.1)

Nearside Front Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Macpherson strut corroded but not seriously weakened (2.4.G.1)

Nearside Rear Road wheel with a slightly distorted bead rim (4.2.A.1a)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Macpherson strut corroded but not seriously weakened (2.4.G.1)

Offside Front Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Front Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Nearside Front Tyre worn close to the legal limit 3mm (4.1.E.1)

Offside Front Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement rear bush (2.4.G.2)

Offside Rear Tyre worn close to the legal limit 3mm (4.1.E.1)

Nearside Front Suspension arm rubber bush bonding deteriorated resulting in excessive movement rear bush (2.4.G.2)

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Front Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Nearside Front Tyre worn close to the legal limit 3mm (4.1.E.1)

Offside Front Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement rear bush (2.4.G.2)

Offside Rear Tyre worn close to the legal limit 3mm (4.1.E.1)

N/S/F TYRE IS WORN TO 2/3/2mm

O/S/F TYRE IS WORN TO 3/3/3mm