2006 Toyota Aygo

Nearside Front Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))

Nearside Front Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Headlamp aim too low (4.1.2 (a))

Nearside Rear Outer Vehicle structure inadequately repaired such that structural rigidity is significantly reduced Sill (6.1.1 (d) (i))

Offside Front Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Suspension arm pin or bush excessively worn Rear bush (5.3.4 (a) (i))

Offside Front Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Headlamp has a product on the lens so that the light output is severely reduced (4.1.4 (b))

Offside Rear Inner Brake pipe excessively corroded (1.1.11 (c))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Tyre has ply or cords exposed (5.2.3 (d) (ii)) DANGEROUS

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Front Windscreen wiper blade defective (3.4 (b) (i))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Rear Axle Corroded

Central Exhaust has a major leak of exhaust gases (6.1.2 (a))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust emissions likely to be affected by an exhaust leak (8.2.1.1 (b))

Nearside Rear Brake pipe excessively corroded (1.1.11 (c))

Offside Headlamp has a product on the light source but not seriously reducing light output (4.1.4 (b))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Front Anti-roll bar pin or bush worn but not resulting in excessive movement front (5.3.4 (a) (i))

corrosion under vehicle

Driver's view of the road through the swept area of the windscreen materially affected by an obstruction (3.1 (a) (ii))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill marked (5.3.6 (a) (i))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Tyre not fitted in accordance with side wall instructions (5.2.3 (i))

Front Anti-roll bar pin or bush worn but not resulting in excessive movement front (5.3.4 (a) (i))

both front tyres worn inner edges

corrosion under vehicle

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Oil leak ()

brake disc worn, pitted or scored, but not seriously weakened Both front (3.5.1i)

Emissions not tested (7.3.A.1)

Rear Exhaust has a major leak of exhaust gases Silencer (7.1.2)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Oil leak ()

brake disc worn, pitted or scored, but not seriously weakened Both front (3.5.1i)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front position lamp(s) not working (1.1.A.3b)

Offside Front position lamp(s) not working (1.1.A.3b)

Nearside Front Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Bonnet release handle not working

N/S/F CV boot sealed with silicone

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

front brake discs corroded

Rear Exhaust has part of the system slightly deteriorated (7.1.1a)

front brake discs becoming corroded