2009 Ford Ka

Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Suspension component mounting repair covered in underseal (5.3.6 (a) (i))

Front Power steering pipe/hose slightly corroded (2.1.5 (g) (i))

Nearside Front Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Nearside Rear Upper Suspension component pin or bush slightly worn (5.3.4 (a) (i))

Offside Front Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Offside Rear Upper Suspension component pin or bush slightly worn (5.3.4 (a) (i))

Nearside Front Integral body structure is fractured and structural rigidity is significantly reduced (6.1.1 (a) (i))

Front Power steering pipe/hose slightly corroded (2.1.5 (g) (i))

Nearside Front Anti-roll bar ball joint has slight play (5.3.4 (a) (i))

Nearside Front Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Nearside Rear Upper Suspension component pin or bush slightly worn (5.3.4 (a) (i))

Offside Front Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Offside Rear Upper Suspension component pin or bush slightly worn (5.3.4 (a) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced front & rear (6.1.1 (c) (i))

floor corroded

Nearside Front Brake prescribed area is excessively corroded inner wing at brake hose mount (1.1.21 (e) (i))

Nearside Front Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill at axle mount (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Nearside Rear Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill at axle mount (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced front & rear (6.1.1 (c) (i))

floor corroded

Offside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Front Windscreen washer provides insufficient washer liquid (3.5 (a))

Offside Parking brake inoperative on one side (1.4.1 (a))

Offside Rear Tyre(s) of different sizes are fitted on the same axle. (5.2.3 (b))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Offside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Suspension component mounting prescribed area is corroded but not considered excessive inner/outer sill areas (5.3.6 (a) (i))

Offside Rear Position lamp not working (4.2.1 (a) (ii))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Suspension component mounting prescribed area is corroded but not considered excessive inner/outer sill areas (5.3.6 (a) (i))

Offside Headlamp not working on main beam (4.1.1 (a) (ii))

Rear Exhaust emissions likely to be affected by an exhaust leak (8.2.1.1 (b))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii))

Offside Headlamp aim too low (1.8)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Front Direction indicator not working (1.4.A.2c)

Offside Front Power steering pipe(s) or hose(s) leaking from a joint (2.3.3b)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)