2012 Hyundai I30

Front Suspension arm pin or bush worn but not resulting in excessive movement frontmost bush both sides (5.3.4 (a) (i))

Front subframe and suspension arms corroded

Fuel Pipe/s corroded filler pipes ()

Nearside Registration plate lamp missing in the case of multiple lamps or light sources (4.7.1 (b) (i))

Rear Suspension arm pin or bush worn but not resulting in excessive movement all bushes perishing and splitting (5.3.4 (a) (i))

Rear back plates corroded/breaking up

Rear subframe and suspension arms corroded

Suspension component mounting prescribed area is corroded but not considered excessive inner sill both sides (5.3.6 (a) (i))

dampness around fuel tank

secondary bonnet catch inop

Nearside Position lamp not working (4.2.1 (a) (ii))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength control arm inner bolt mounting on subframe (5.3.6 (a) (i))

Front Suspension arm pin or bush worn but not resulting in excessive movement frontmost bush both sides (5.3.4 (a) (i))

Front subframe and suspension arms corroded

Fuel Pipe/s corroded filler pipes ()

Nearside Registration plate lamp missing in the case of multiple lamps or light sources (4.7.1 (b) (i))

Rear Suspension arm pin or bush worn but not resulting in excessive movement all bushes perishing and splitting (5.3.4 (a) (i))

Rear back plates corroded/breaking up

Rear subframe and suspension arms corroded

Suspension component mounting prescribed area is corroded but not considered excessive inner sill both sides (5.3.6 (a) (i))

dampness around fuel tank

secondary bonnet catch inop

Front Suspension arm pin or bush worn but not resulting in excessive movement front bush both arms (5.3.4 (a) (i))

Front top mounts sticking.

Nearside Front Service brake binding but not excessively (1.2.1 (f))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources bulb inop and bulb holder missing. (4.7.1 (b) (i))

Rear exhaust hanger corroded

bonnet secondary catch poor condition.

front and rear subfames corroded

Nearside Front Service brake fluctuating, but not excessively (1.2.1 (e))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Service brake fluctuating, but not excessively (1.2.1 (e))

Nearside Front Lower Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Front Service brake fluctuating, but not excessively (1.2.1 (e))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Service brake fluctuating, but not excessively (1.2.1 (e))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Nearside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Nearside Front All position lamps not working (4.2.1 (a))

Nearside Front Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Nearside Front position lamp(s) not working (1.1.A.3b)

Offside Front position lamp(s) not working (1.1.A.3b)

Front Brake pad(s) wearing thin (3.5.1g)

Front brake disc worn, pitted or scored, but not seriously weakened both (3.5.1i)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside Registration plate lamp not working (1.1.C.1d)

Rear Brake pad(s) wearing thin (3.5.1g)

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Front position lamp(s) not working (1.1.A.3b)

Offside Headlamp aim too low (1.8)

Rear Brake pad(s) wearing thin (3.5.1g)

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)