2013 Mercedes-benz Sprinter

Integral body structure is deformed but structural rigidity is not significantly reduced Damage to the nearside and offside outer sills (6.1.1 (a) (i))

Electronic stability control warning lamp indicates a fault (7.12 (e))

Engine MIL inoperative or indicates a malfunction (8.2.2.2 (g))

Nearside Front Bumper insecure (6.1.4 (a) (i))

Nearside Rear Outline marker lamp not working (4.2.1 (a) (ii))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Front Lower Suspension component ball joint likely to become detached (5.3.4 (a) (ii)) DANGEROUS

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Exhaust mounting defective Weld on the Hanging brackets has broken, (6.1.2 (a))

Integral body structure is deformed but structural rigidity is not significantly reduced Damage to the nearside and offside outer sills (6.1.1 (a) (i))

Offside Front Side repeater lens defective which has no effect on emitted light Lens is broken (4.4.1 (b) (i))

Front Exhaust mounting defective at flexi (6.1.2 (a))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear Exhaust mounting defective at tailpipe (6.1.2 (a))

Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Front Windscreen washer provides insufficient washer liquid (3.5 (a))

Nearside Brake pipe excessively corroded front to rear (1.1.11 (c))

Nearside Front Bumper insecure (6.1.4 (a) (i))

Nearside Rear Bumper insecure (6.1.4 (a) (i))

Nearside Rear Outline marker lamp does not illuminate simultaneously with the position lamps (4.2.2 (a))

Nearside Rear Rear reflector missing (4.8.2 (a) (ii))

Offside Brake pipe excessively corroded front to rear (1.1.11 (c))

Offside Rear Rear reflector likely to become detached (4.8.1 (b) (ii))

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Front Exhaust mounting defective at flexi (6.1.2 (a))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear Exhaust mounting defective at tailpipe (6.1.2 (a))

Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Both front to rear brake pipes slightly corroded

Rear Brake discs and pads deteriorated

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Windscreen slight damage

Both front to rear brake pipes slightly corroded

Headlamp aim too high Both (4.1.2 (a))

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Rear Brake discs and pads deteriorated

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Windscreen slight damage

Offside Play in steering rack inner joint(s) ()

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Electronic stability control warning lamp indicates a fault (7.12 (e))

Parking brake efficiency below requirements (1.4.2 (a) (i))