2007 Peugeot 206

Nearside Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting central sill (6.2.2 (d) (i))

Offside Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting sill holed (6.2.2 (d) (i))

Brake pipe corroded, covered in grease or other material both front to rear (1.1.11 (c))

Offside Registration plate lamp throwing direct white light to the rear (4.7.1 (a))

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Fuel tank insecure strap brocken (6.1.3 (a) (i))

Nearside Rear Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Offside Rear Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Offside Front Tyre tread pattern not visible over the whole tread area when minimum depth required is 1.0mm (5.2.3 (e)) DANGEROUS

Offside Front Tyre tread pattern not visible over the whole tread area when minimum depth required is 1.0mm (5.2.3 (e)) DANGEROUS

Offside Rear Suspension arm likely to fail (5.3.3 (b) (ii)) DANGEROUS

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement front bush (5.3.4 (a) (i))

Offside Front Brake actuating linkage mounting prescribed area is excessively corroded Bulkhead (3.3.A.2)

Rear fog lamp not working (1.3.2b)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Front Lower Suspension arm has slight play in a ball joint (2.4.G.2)

front tyres heavily worn on inner edges and heavily perished/cracked

o/s/r axle bearing excessively worn but no fouling on body from wheel/tyre

spare wheel corroded

Nearside Front coil spring broken (2.4.C.1a)

Nearside Headlamp aim too high (1.8)

Nearside Front Shock absorber has slight corrosion to the casing (2.7.2a)

Offside Front Shock absorber has slight corrosion to the casing (2.7.2a)

Under-trays fitted obscuring some underside components

Nearside Front Shock absorber has an excessively worn shock absorber pivot (2.7.4)

Nearside Rear Registration plate lamp not working (1.1.C.1d)

Nearside rear brake binding (3.7.B.1)

Offside Rear Registration plate lamp not working (1.1.C.1d)

Rear rear brake binding (3.7.B.1)

Nearside Front Shock absorber has slight corrosion to the casing (2.7.2a)

Offside Front Shock absorber has slight corrosion to the casing (2.7.2a)

Nearside Front Front constant velocity joint gaiter insecurely mounted to its housing (2.5.C.1a)