2012 Land Rover Discovery

Nearside Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Rear Lower Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Rear Lower Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Exhaust emissions likely to be affected by an exhaust leak injector fault (8.2.2.1 (b))

Offside Front Wheel bearing has excessive play (5.1.3 (a) (i))

Offside Rear Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Front Brake hose ferrule excessively corroded (1.1.12 (f) (i))

Offside Front Brake hose ferrule excessively corroded (1.1.12 (f) (i))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Front Registration plate insecure but not likely to fall off (0.1 (a))

Central Prop shaft bearing excessively worn (6.1.7 (b) (i))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Nearside Front Wheel bearing play so excessive it is likely to break up (5.1.3 (a) (ii)) DANGEROUS

Front Registration plate insecure but not likely to fall off (0.1 (a))

emissions to low to be detected at tail pipe

under trays and engine covers fitted obscuring some components

Nearside Rear Brake pipe excessively corroded front to rear going to nsr flexi pipe (3.6.B.2c)

Nearside Rear Tyre has a lump, caused by separation or partial failure of its structure (4.1.D.1b)

Offside Rear Brake pipe excessively corroded front to rear going to osr flexi pipe (3.6.B.2c)

emissions to low to be detected at tail pipe

under trays and engine covers fitted obscuring some components

Offside Rear Tie bar/rod has slight play in a pin/bush (2.4.G.2)

Nearside Rear Registration plate lamp does not illuminate simultaneously with the position lamps (1.1.C.1a)

Offside Rear Registration plate lamp does not illuminate simultaneously with the position lamps (1.1.C.1a)

Offside Rear Tie bar/rod has slight play in a pin/bush (2.4.G.2)

Nearside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Headlamp not working on dipped beam (1.7.5a)