2005 Jaguar S-type

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Electronic stability control warning lamp indicates a fault (7.12 (e))

Horn not working (7.7 (a) (ii))

Nearside Front Service brake excessively binding (1.2.1 (f))

Nearside Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting complete outer sill (6.2.2 (d) (i))

Nearside Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting chassis (6.2.2 (d) (i))

Nearside Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting inner sill (6.2.2 (d) (i))

Offside Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting complete outer sill (6.2.2 (d) (i))

Offside Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting inner sill (6.2.2 (d) (i))

Windscreen washer not working (3.5 (a))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Coil spring corroded all (5.3.1 (b) (i))

Offside Rear Direction indicator slightly discoloured (4.4.3 (a))

corrosion to under surface of vehicle

general corrosion, especially at the rear.

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Front brakes can be felt dragging when rotated by hand, further investigation recommended.

Nearside Rear Tyre worn close to the legal limit on min limit (4.1.E.1)

general corrosion, especially at the rear.

O/side front tyre worn on inner tread

O/side front tyre worn on inner tread

Offside Headlamp aim too low (1.8)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

all brakes dragging slightly,brake service recommended

front brake pads appear to be worn low

Electronic parking brake warning indicates a malfunction (3.1.7)

Front Headlamp cleaning device inoperative (1.7.2)

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

Nearside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front front brake binding (3.7.B.1)

Offside Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Rear Electrical wiring damaged and bare wires exposed (1.9.2c)

Parking brake: efficiency below requirements (3.7.B.7)

Windscreen washer provides insufficient washer liquid (8.2.3)

Brake pipe slightly corroded (3.6.B.2c)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Tie bar/rod rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear Upper Suspension arm has slight play in a pin/bush (2.4.G.2)

Offside Front Tie bar/rod rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

front brake hose ferruls corroded

general underbody corrosion

recommend removal of both outer sill covers to inspect fully

some movement in steering column top mounting

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Offside Front Tyre has ply or cords exposed (4.1.D.1b)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)