2010 Kia Picanto

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Track rod end ball joint has slight play (2.1.3 (b) (i))

sump pan corroded

Brake pipe excessively corroded rear section of n/s front to rear (1.1.11 (c))

Offside Rear Coil spring fractured or broken (5.3.1 (b) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Registration plate lamp inoperative in the case of a single lamp or all lamps o/s and n/s (4.7.1 (b) (ii))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Nearside Front Track rod end ball joint has slight play (2.1.3 (b) (i))

sump pan corroded

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Brake lever has insufficient reserve travel (1.1.2 (a))

Nearside Parking brake inoperative on one side (1.4.1 (a))

Offside Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Central Exhaust has a major leak of exhaust gases (6.1.2 (a))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Exhaust has a major leak of exhaust gases (6.1.2 (a))

Offside Rear wheel has restricted movement

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front Lower ball joint gaiter perished

Rear discs lipped and corroded

Nearside Front Track rod end ball joint has excessive play (2.1.3 (b) (i))

Offside Front Lower ball joint gaiter perished

Rear discs lipped and corroded

Offside Front Lower Suspension arm ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

rear wiper blade worn no blade

Nearside Front Inner Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Front Lower Suspension arm ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

rear wiper blade worn no blade

Brake pad(s) wearing thin front brake pads approx. 3mm (3.5.1g)

Offside Front Front suspension ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Tyre worn close to the legal limit both front tyres slightly low (4.1.E.1)

Tyre worn close to the legal limit both rear tyres approx. 2mm, advise renewal (4.1.E.1)

engine oil sump pan corroded and starting to leak

rear wiper blade unserviceable advise renewal

Parking brake: efficiency below requirements (3.7.D.4)

Windscreen wiper does not clear the windscreen effectively both sides front (8.2.2)

Brake pad(s) wearing thin front brake pads approx. 3mm (3.5.1g)

Offside Front Front suspension ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Tyre worn close to the legal limit both front tyres slightly low (4.1.E.1)

Tyre worn close to the legal limit both rear tyres approx. 2mm, advise renewal (4.1.E.1)

engine oil sump pan corroded and starting to leak

rear wiper blade unserviceable advise renewal

both rear tyre tread depths 3mm

Front Exhaust system not adequately supported (7.1.1)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

centre exhaust mount corroded off

n/s/f tyre 5mm

o/s/f tyre 3-4mm on inner edge