2009 Mercedes-benz C

Offside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Front Suspension arm pin or bush worn but not resulting in excessive movement n/s and o/s (5.3.4 (a) (i))

Rear Brake pipe corroded, covered in grease or other material n/s and o/s (1.1.11 (c))

Brake pedal has insufficient reserve travel (1.1.2 (a))

Service brake efficiency below requirements (1.2.2 (a) (i))

Front Suspension arm pin or bush worn but not resulting in excessive movement n/s and o/s (5.3.4 (a) (i))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Rear Brake pipe corroded, covered in grease or other material n/s and o/s (1.1.11 (c))

Nearside Front Headlamp aim too low (4.1.2 (a))

Service brake efficiency below requirements (1.2.2 (a) (i))

Front Suspension arm pin or bush worn but not resulting in excessive movement both side (5.3.4 (a) (i))

Nearside Rear Nail in tyre ()

Front Brake disc worn, but not excessively (1.1.14 (a) (i))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Tyre worn close to legal limit/worn on edge both (5.2.3 (e))

rear suspension area, frame, springs, and others components corroded

Offside Front Coil spring fractured or broken (5.3.1 (b) (i))

Front Brake disc worn, but not excessively (1.1.14 (a) (i))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Tyre worn close to legal limit/worn on edge both (5.2.3 (e))

rear suspension area, frame, springs, and others components corroded

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Upper Suspension arm pin or bush worn but not resulting in excessive movement n/s and o/s (5.3.4 (a) (i))

Electronic stability control warning lamp indicates a fault (7.12 (e))

Nearside Rear Subframe mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Upper Suspension arm pin or bush worn but not resulting in excessive movement n/s and o/s (5.3.4 (a) (i))

Offside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Front Headlamp aim too high (4.1.2 (a))

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)