1999 Daihatsu Cuore

Nearside Front Lower Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Rear Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Rear Brakes imbalanced across an axle (1.2.1 (b) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Brake hydraulic reservoir fluid level below minimum level (1.1.10 (d) (i))

Front Upper Suspension spring mounting prescribed area is corroded but not considered excessive both sides (5.3.6 (a) (i))

Offside Rear Suspension spring mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Rear Lower Seat belt anchorage prescribed area is corroded but not considered excessive both sides (7.1.1 (a) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive both sides (5.3.6 (a) (i))

Rear Tyre worn close to legal limit/worn on edge both sides (5.2.3 (e))

Vehicle structure is corroded but structural rigidity is not significantly reduced all (6.1.1 (c) (i))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

both inner and outer sills corroded

rear inner wheel archs corroded

Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Lower Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Nearside Rear Lower Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Rear Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear Tyre worn close to the legal limit and both perished (4.1.E.1)

both inner sills corroded

floor pan corroded

Front Windscreen wiper does not clear the windscreen effectively both (8.2.2)

Nearside Front Lower Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Lower Suspension arm has excessive play in a ball joint (2.4.G.2)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Lower Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Rear registration plate deteriorated (6.3.1d)

Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Rear Lower Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Rear Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear Tyre worn close to the legal limit and both perished (4.1.E.1)

both inner sills corroded

floor pan corroded

Front Lower Seat belt anchorage prescribed area is corroded but not considered excessive both sides (5.2.6)

Front Lower Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt both sides (2.4.G.2)

Front Tyre worn close to the legal limit both sides (4.1.E.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Rear Brake pipe slightly corroded both sides (3.6.B.2c)

Rear Suspension component mounting prescribed area is corroded but not considered excessive both sides (2.4.A.3)

Rear Suspension spring mounting prescribed area is corroded but not considered excessive both sides (2.4.A.3)

Rear registration plate deteriorated but not likely to be misread (6.3.1d)

floor pan corroded

inner sills corroded

o/s/r outer sill corroded

Front Sub-frame corroded but not seriously weakened (2.4.G.1)

Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Front Lower Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Offside Front Lower Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Rear Lower Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear Upper Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear registration plate deteriorated but not likely to be misread (6.3.1d)

n/s/f bumper a little loose

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Lower Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Nearside Front Upper Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Lower Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Offside Front Upper Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear registration plate deteriorated but not likely to be misread (6.3.1d)

rear back of drivers seat a bit wobbly

Front Sub-frame attachment bracket/mounting insecure (2.4.G.1)

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Rear Lower Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Lower Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Lower Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Nearside Front Upper Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Lower Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Offside Front Upper Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear registration plate deteriorated but not likely to be misread (6.3.1d)

rear back of drivers seat a bit wobbly

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Rear Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Lower Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear registration plate deteriorated but not likely to be misread (6.3.1d)

Nearside Front Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Offside Front Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Rear registration plate deteriorated but not likely to be misread (6.3.1d)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Rear registration plate deteriorated but not likely to be misread (6.3.1d)

Brakes imbalanced across an axle (3.7.B.5b)

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

Rear Exhaust has part of the system slightly deteriorated (7.1.1a)

Rear registration plate deteriorated but not likely to be misread (6.3.1d)

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

rear no. plate a little dirty

osr tyre low on edge

rear tyres perishing

wipers slightly smeary

Brakes imbalanced across an axle (3.7.B.5b)

Front brake disc slightly pitted (3.5.1h)

front brakes binding

front tyres perrishing in tread

rear tyres badley perrished

Front brake disc slightly pitted (3.5.1h)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)