1999 Honda Civic

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive inner wheel arch area (5.3.6 (a) (i))

Rear Exhaust mounting defective (6.1.2 (a))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Emissions not tested (8.2.1.2 (d))

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Front passenger door cannot be opened from inside the vehicle (6.2.3 (a))

Front passenger door cannot be opened from outside the vehicle (6.2.3 (a))

Nearside Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced floor (6.1.1 (c) (i))

Nearside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced chassis (6.1.1 (c) (i))

Nearside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced inner sill areas (6.1.1 (c) (i))

Offside Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced floor (6.1.1 (c) (i))

Offside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced chassis (6.1.1 (c) (i))

Offside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced inner sill areas (6.1.1 (c) (i))

Emissions not tested due to holes in exhaust and not being able to get correct reading (8.2.1.2 (d))

Exhaust emissions likely to be affected by an exhaust leak (8.2.2.1 (b))

Headlamp aim too low will not adjust from adjuster on back of headlamp (4.1.2 (a))

Nearside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Rear Bumper insecure arch to bumper mounting point corroded to extent bumper not being secured anymore. (6.1.4 (a) (i))

Nearside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced jacking point (6.1.1 (c) (i))

Offside Front Headlamp has a product on the lens so that the light output is severely reduced (4.1.4 (b))

Offside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced chassis above exhaust over rear axle (6.1.1 (c) (i))

Offside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced jacking point (6.1.1 (c) (i))

Rear fog lamp not working (4.5.1 (a) (ii))

Nearside Front Anti-roll bar pin or bush worn but not resulting in excessive movement d bush (5.3.4 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Anti-roll bar pin or bush worn but not resulting in excessive movement d bushes both sides (5.3.4 (a) (i))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

slight chip in zone (a) of screen

Offside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Rear fog lamp not working (4.5.1 (a) (ii))

Brake fluid close to minimum mark (1.1.10 (d) (ii))

Nearside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Becoming perished

Rear Exhaust becoming corroded at joint

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Nearside Front passenger door cannot be opened from inside the vehicle (6.2.3 (a))

Nearside Front passenger door cannot be opened from outside the vehicle (6.2.3 (a))

Nearside Headlamp aim too low does not seem to adjust. (4.1.2 (a))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill/lower rear quarter panel. (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill/lower rear quarter panel. (5.3.6 (a) (i))

Windscreen washer not working (3.5 (a))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

rear x member corroded

Brake pipe slightly corroded 2 front to rear brake pipes corroded (3.6.B.2c)

Nearside Rear Suspension arm rubber bush deteriorated but not resulting in excessive movement trailing arm (2.4.G.2)

Offside Front brake binding on

Offside Rear Suspension arm rubber bush deteriorated but not resulting in excessive movement trailing arm (2.4.G.2)

Nearside Rear Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Outer Steering rack gaiter deteriorated (2.2.D.2d)

Offside Rear Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Rear Brake pad(s) wearing thin 2 (3.5.1g)

Rear Brake pipe slightly corroded 2 (3.6.B.2c)

Rear brake disc worn, pitted or scored, but not seriously weakened 2 (3.5.1i)

Rear Brake pad(s) wearing thin (3.5.1g)

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front coil spring corroded (2.4.C.1b)

Offside Front wheel bearing has slight play (2.5.A.3c)

Offside Inner Ball joint has slight play (2.2.B.1f)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

o/s/r brake binds

Rear Brake pad(s) wearing thin (3.5.1g)

Rear brake disc slightly pitted (3.5.1h)

Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)