1999 Honda Civic

Exhaust emissions likely to be affected by an exhaust leak (8.2.2.1 (b))

Exhaust has a major leak of exhaust gases Middle and Rear silencers snapped (6.1.2 (a))

Front Anti-roll bar linkage pin or bush excessively worn Both sides (5.3.4 (a) (i))

Nearside Front Shock absorbers has a serious fluid leak (5.3.2 (b))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Power steering component leaking Steering rack (2.1.5 (a))

Rear Suspension arm pin or bush excessively worn Both sides axle bushes (5.3.4 (a) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

Coil spring corroded All (5.3.1 (b) (i))

General corrosion to chassis

Oil leak, but not excessive Sump corroded (8.4.1 (a) (i))

Registration plate deteriorated but not likely to be misread Front and Rear (0.1 (b))

Shock absorbers has a slightly worn bush All lower shock absorber mounting points (5.3.2 (c))

Tyre slightly damaged/cracking or perishing All (5.2.3 (d) (ii))

Exhaust has a minor leak of exhaust gases on pipe welded up, joints slight blow from both (6.1.2 (a))

all bush's perishing and all shockers slight dampness

under body heavy corrosion

Exhaust has a minor leak of exhaust gases on pipe welded up, joints slight blow from both (6.1.2 (a))

Nearside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

all bush's perishing and all shockers slight dampness

under body heavy corrosion

all brake pipes all heavy metals all exhaust heavy corrosion

all bush,s perishing as is tyres

suspect nearside drive shaft noisy

Exhaust has a major leak of exhaust gases three place welded up (7.1.2)

all brake pipes all heavy metals all exhaust heavy corrosion

all bush,s perishing as is tyres

suspect nearside drive shaft noisy

all rubber bush's perishing

front tyres inner side walls splitting

heavy corrosion to heavy metals

Nearside Front Shock absorber has a light misting of oil (2.7.3)

heavy lip on front disc's

slight blow from mid exhaust

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Headlamp not working on dipped beam (1.7.5a)

Offside Front Headlamp aim too low (1.8)

heavy lip on front disc's

slight blow from mid exhaust

both front antiroll bar stabiliser link bushes cracking

front no plate cracked

rear suspension radius arm bushes cracking

steering rack slightly damp

stone chip on zone a 2mm

Supplementary Restraint System warning lamp indicates a fault (5.4.2)

both front antiroll bar stabiliser bushes cracking

nearside front shock absorber damp

rear suspension radius arms,main bushes cracking

steering rack slightly damp

stone chip on zone a 2mm

Offside Rear Shock absorber has a slightly reduced damping effect (2.7.5)

Direction indicators incorrect colour (1.4.A.2f)

Exhaust tailpipe not capable of allowing the emission probe to be inserted (7.3.D.1)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Stop lamp not working (1.2.1b)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Offside Rear Shock absorber has a slightly reduced damping effect (2.7.5)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

both rear tyres wearing low

offside front tyre wearing low

s r s light on dash

Nearside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Rear position lamp(s) adversely affected by the operation of another lamp (1.1.A.3f)

Offside Rear Stop lamp adversely affected by the operation of another lamp (1.2.1f)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Exhaust tailpipe not capable of allowing the emission probe to be inserted (7.3.D.1)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front position lamp(s) not working (1.1.A.3b)

Offside Front Tyre has ply or cords exposed (4.1.D.1b)

Offside Stop lamp not working (1.2.1b)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Horn not working (1.6.2a)

Nearside Front constant velocity joint gaiter split (2.5.C.1a)

Nearside Headlamp not working on dipped beam (1.7.5a)

Registration plate lamp not working (1.1.5c)

Nearside Headlamp not working on dipped beam (1.7.5a)