1999 Vauxhall Corsa

Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Nearside Rear Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Suspension component mounting prescribed area excessively corroded significantly reducing structural strength both rear axle mounts (5.3.6 (a) (i))

Suspension component mounting prescribed area excessively corroded significantly reducing structural strength both rear spring mounts (5.3.6 (a) (i))

Central Exhaust mounting defective (6.1.2 (a))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Passenger seat(s) missing at time of test ()

Rear cross member corroded

Central Exhaust mounting defective (6.1.2 (a))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Nearside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Offside Front Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Offside Front Brake pipe corroded, covered in grease or other material to flexi (1.1.11 (c))

Offside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))

Passenger seat(s) missing at time of test all rear ()

Play in steering rack inner joint(s) both front ()

Rear cross-member corroded

general under-body corrosion

Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Play in steering rack inner joint(s) ()

Parking brake lever has little reserve travel (3.1.6b)

Rear Suspension component mounting prescribed area is corroded but not considered excessive coil springs upper mounts (2.4.A.3)

rear crossmember corroded

rear seats removed at time of test

Exhaust system not adequately supported rear mountings broke (7.1.1)

Front Tyre(s) incorrect because different size tyres are fitted on the same axle. (4.1.A.1a)

Nearside Rear wheel bearing rough when rotated (2.6.1)

Suspension component mounting prescribed area is excessively corroded both rear inner sills (2.4.A.3)

Track rod end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt both front (2.2.C.1c)

Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Play in steering rack inner joint(s) ()

Parking brake lever has little reserve travel (3.1.6b)

Rear Suspension component mounting prescribed area is corroded but not considered excessive coil springs upper mounts (2.4.A.3)

rear crossmember corroded

rear seats removed at time of test

Exhaust has a minor leak of exhaust gases center joint (7.1.2)

Rear Body has slight corrosion cross member. tow bar removed for re test (6.1.B.2)

Track rod end ball joint dust cover deteriorated, but preventing the ingress of dirt both front (2.2.C.1c)

Lower Brake pipe excessively corroded front to rear (3.6.B.2c)

Nearside Rear Rear wheel bearing rough when rotated (2.6.1)

Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings cross member by towbar (6.1.B.2)

Exhaust has a minor leak of exhaust gases center joint (7.1.2)

Track rod end ball joint dust cover deteriorated, but preventing the ingress of dirt both front (2.2.C.1c)

Nearside Front Macpherson strut has slight movement in the upper support bearing assembly (2.5.B.1b)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Obligatory mirror insecure (8.1.1)

Nearside Rear Tyre has a lump, caused by separation or partial failure of its structure (4.1.D.1b)

Nearside rear brake binding (3.7.B.1)

Offside rear brake binding (3.7.B.1)

Parking brake: efficiency below requirements (3.7.B.7) DANGEROUS

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Driver's door hinge deteriorated but the door can still be readily opened and closed (6.2.B.2)

Offside Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Unable to check rear wheel bearings due to brakes binding.

Nearside Front constant velocity joint gaiter insecurely mounted to its housing (2.5.C.1a)

Nearside Brake cable has wires broken and is significantly weakened (3.5.1b)

Registration plate lamp not working (1.1.5c)