1999 Rover 420

Front Exhaust has a major leak of exhaust gases (7.1.2)

Front Subframe mounting prescribed area is excessively corroded both front floors corroded (2.4.A.3)

Offside Front Brake pipe excessively corroded (3.6.B.2c)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Rear Sub-frame has slight play in a pin/bush both (2.4.G.2)

Nearside Front Body has slight corrosion sill (6.1.B.2)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Nearside Rear rear parking brake recording little or no effort (3.7.B.6a)

Power steering pipe(s) or hose(s) leaking from a joint (2.3.3b)

Offside Front constant velocity joint gaiter damaged, but preventing the ingress of dirt (2.5.C.1a)

Offside Front constant velocity joint gaiter damaged, but preventing the ingress of dirt (2.5.C.1a)

Offside Headlamp excessively deteriorated so that the light output is severely reduced (1.7.5a)

Offside Stop lamp not working (1.2.1b)

Registration plate lamp not working (1.1.C.1d)

Nearside Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

rear tyre worn on outer edges

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Headlamp aim too low (1.8)

Offside Headlamp aim too high (1.8)

Nearside Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

rear tyre worn on outer edges

tailbox rear rubber mount no attached

Nearside Front constant velocity joint gaiter split (2.5.C.1a)

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)