1999 Rover Mini

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Front Sub-frame attachment bracket/mounting insecure bolt loose (5.3.3 (a) (i))

Nearside Front Upper Suspension arm ball joint dust cover no longer prevents the ingress of dirt inner (5.3.4 (b) (ii))

Offside Front Sub-frame attachment bracket/mounting insecure bolt loose (5.3.3 (a) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength floor (5.3.6 (a) (i))

Offside Front Upper Suspension arm ball joint dust cover no longer prevents the ingress of dirt inner (5.3.4 (b) (ii))

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength SUBFRAME , O/S/R MOUNT (5.3.6 (a) (i))

Nearside Front Upper Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Nearside Rear Service brake effort inadequate at a wheel (1.2.1 (a) (i))

Offside Rear Service brake effort inadequate at a wheel (1.2.1 (a) (i))

Rear Subframe mounting prescribed area excessively corroded significantly reducing structural strength SUBFRAME , N/S/R FRONT MOUNT (5.3.6 (a) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

Offside Front Upper Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Front Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Front Upper Steering linkage ball joint ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Offside Front Lower Steering linkage ball joint ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Offside Front Outer Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Exhaust has a major leak of exhaust gases centre (7.1.2)

Nearside Front Direction indicator incorrect colour (1.4.A.2f)

Nearside Front Front suspension has excessive play in a upper suspension ball joint (2.5.B.1a)

Nearside Front Sub-frame damaged and seriously weakened (2.4.G.1)

Nearside Rear Direction indicator not working (1.4.A.2c)

Nearside Rear Radius arm has excessive play in a pin/bush (2.4.G.2)

Nearside Rear Suspension component mounting prescribed area is excessively corroded shock absorber mount (2.4.A.3)

Nearside Steering rack gaiter split (2.2.D.2d)

Nearside rear brake recording little or no effort (3.7.B.5a)

Offside Front Direction indicator incorrect colour (1.4.A.2f)

Offside Front Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Offside Front Suspension component mounting prescribed area is excessively corroded shock absorber mount (2.4.A.3)

Offside Rear Radius arm has excessive play in a pin/bush (2.4.G.2)

Offside Rear Sub-frame corroded and seriously weakened (2.4.G.1)

Offside Rear Suspension component mounting prescribed area is excessively corroded shock absorber mounting (2.4.A.3)

Offside Steering rack gaiter split (2.2.D.2d)

Rear Brakes imbalanced across an axle Axle 2 (3.7.B.5b)

Brake pipe slightly corroded front to rear (3.6.B.2c)

Offside Rear Shock absorber has a light misting of oil (2.7.3)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Exhaust emissions hydrocarbon content after 2nd fast idle excessive (7.3.D.3)

Exhaust engine idle speed too high (7.3.D.1)

Nearside Upper Front suspension ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside rear brake recording little or no effort (3.7.B.5a)

Offside rear brake recording little or no effort (3.7.B.5a)

Service brake: efficiency below requirements (3.7.B.7)

Nearside Rear Sub-frame corroded and seriously weakened (2.4.G.1)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Front Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Headlamp aim too low and too far to the right. (1.8)

Centre Exhaust has part of the system slightly deteriorated (7.1.1a)

Nearside Front Lower Shock absorber has a slightly worn bush (2.7.4)

Nearside Front Suspension arm has slight play in a ball joint (2.4.G.2)

Nearside Rear Lower Shock absorber has a slightly worn bush (2.7.4)

Nearside Rear Radius arm has slight play in a pin/bush (2.4.G.2)

Offside Rear Radius arm has slight play in a pin/bush (2.4.G.2)

Offside Vehicle structure has slight corrosion (6.1.B.2)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Nearside Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Front Suspension has inadequate clearance with the bump stop (2.4.A.1a)

Centre Exhaust has part of the system slightly deteriorated (7.1.1a)

Nearside Front Lower Shock absorber has a slightly worn bush (2.7.4)

Nearside Front Suspension arm has slight play in a ball joint (2.4.G.2)

Nearside Rear Lower Shock absorber has a slightly worn bush (2.7.4)

Nearside Rear Radius arm has slight play in a pin/bush (2.4.G.2)

Offside Rear Radius arm has slight play in a pin/bush (2.4.G.2)

Offside Vehicle structure has slight corrosion (6.1.B.2)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Nearside Front Suspension has inadequate clearance with the bump stop (2.4.A.1a)

Offside Front Suspension has inadequate clearance with the bump stop (2.4.A.1a)

Offside Front Tie bar/rod rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Nearside Front wheel bearing has slight play (2.5.A.3c)

Nearside Rear Radius arm has slight play in a pin bearing (2.4.G.2)

Offside Front suspension has slight play in a upper suspension ball joint (2.5.B.1a)

Centre Exhaust has a major leak of exhaust gases (7.1.2)

Emissions not tested (7.0)

Offside Front Tie bar/rod has excessive play in a pin/bush (2.4.G.2)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Registration plate lamp not working (1.1.5c)

Nearside Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

Offside Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)