1999 Mazda Bongo

Brake pipe corroded, covered in grease or other material front to rear (1.1.11 (c))

Nearside Front Tyre worn close to legal limit/worn on edge 195/70/15c (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge 195/70/15c (5.2.3 (e))

Oil leak, but not excessive (8.4.1 (a) (i))

Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength cross member (5.3.6 (a) (i))

Fuel cap/sealing device missing (6.1.3 (b) (i))

Horn not working (7.7 (a))

Nearside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Rear Rear fog lamp not working (4.5.1 (a) (ii))

Brake pipe corroded, covered in grease or other material front to rear (1.1.11 (c))

Front Headlamp lens slightly defective both sides (4.1.1 (b) (i))

Nearside Front Tyre worn close to legal limit/worn on edge 195/70/15c (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge 195/70/15c (5.2.3 (e))

Oil leak, but not excessive (8.4.1 (a) (i))

Offside Front Inner Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Rear fog lamp not working (4.5.1 (a) (ii))

Nearside Rear Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Brake lever has very little reserve travel

Offside Front Lower Antiroll bar link dust cover perished

Offside Outer Sill corroded & holed but not within 30cm of suspension /seat belts

Offside Rear Bump stop missing

Rear Anti-roll bar linkage pin or bush worn but not resulting in excessive movement 'D' both (5.3.4 (a) (i))

Rear Upper Both coil spring mounting area corroded but not holed

Horn not working (7.7 (a))

Nearside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Front Outer Track rod end ball joint dust cover missing (2.1.3 (g) (ii))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Cross member (5.3.6 (a) (i))

Offside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Headlamp lens seriously defective No pattern (4.1.1 (b) (ii))

Offside Rear Upper Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Shock absorber mount area (5.3.6 (a) (i))

Offside Rear fog lamp not working (4.5.1 (a) (ii))

Brake lever has very little reserve travel

Nearside Front Lower Suspension component ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Headlamp lens slightly defective pattern ok (4.1.1 (b) (i))

Offside Front Lower Antiroll bar link dust cover perished

Offside Front Lower Suspension component ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Front Outer Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt loose (2.1.3 (g) (i))

Offside Outer Sill corroded & holed but not within 30cm of suspension /seat belts

Offside Rear Bump stop missing

Rear Anti-roll bar linkage pin or bush worn but not resulting in excessive movement 'D' both (5.3.4 (a) (i))

Rear Upper Both coil spring mounting area corroded but not holed

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Offside Front Inner Vehicle structure is corroded but structural rigidity is not significantly reduced cill area (6.1.1 (c) (i))

Offside Front Outer Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Brake disc worn, but not excessively (1.1.14 (a) (i))

Rear Vehicle structure is corroded but structural rigidity is not significantly reduced crossmember area (6.1.1 (c) (i))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Exhaust has a major leak of exhaust gases rear back box (6.1.2 (a))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

front wipers split

headlamps faded

rear pads look low

General underside starting to get abit of surface corrosion in places

O/S Inner sill areas starting to get abit corroded in places

Rear b/discs abit corroded at inner and outer face edges (esp inner faces)

Space saver tyre under pressure (Flat)

Tailgate strutts getting abit weak

O/S/R end crossmember area next to spare tyre, corroded through (NOT fail limits)

Rear b/discs abit corroded at inner faces

Rear b/pads appear abit low

Exhaust has a major leak of exhaust gases Exhaust system broken away at rear area by axle (7.1.2)

Exhaust system not adequately supported Rear silencer section (7.1.1)

Nearside Front Subframe mounting prescribed area is excessively corroded N/S/F end crossmember/radiator mounting area (2.4.A.3)

O/S/R end crossmember area next to spare tyre, corroded through (NOT fail limits)

Rear b/discs abit corroded at inner faces

Rear b/pads appear abit low

Spare tyre low on pressure (soft)