1999 Triumph Daytona

Exhaust noisy (8.1.1 (a))

Steering headbearing slightly stiff or notchy Slightly notchy (2.2.2 (f) (i))

Front Wheel bearing has excessive play Or wheel incorrectly installed (5.1.3 (a) (i))

Nearside Front Shock absorber has a serious fluid leak (5.3.2 (b))

Offside Front Brake disc contaminated (1.1.14 (b))

Offside Front Brake pad(s) contaminated (1.1.13 (b))

Offside Front Shock absorber has a serious fluid leak (5.3.2 (b))

Rear reflector missing (4.8.2 (a) (ii))

Exhaust noisy (8.1.1 (a))

Steering headbearing slightly stiff or notchy Slightly notchy (2.2.2 (f) (i))

Exhaust noisy (7.1.2)

Exhaust noisy (7.1.2)

Nearside Rear Indicator switch does not operate the direction indicators on the side selected (1.5.4)

Offside Rear Indicator switch does not operate the direction indicators on the side selected (1.5.4)

Rear position lamp does not illuminate immediately when it is switched on (1.1.3a)

Exhaust noisy (7.1.2)

Exhaust noisy (7.1.2)

Headlamp aim too low (1.6)

Front Brake pad(s) close to minimum limit (3.2.A1f(i))

Rear shock absorber has a slightly reduced damping effect (2.4.A.3b)

Front Brake pad(s) close to minimum limit (3.2.A1f(i))

Rear Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Rear shock absorber has a slightly reduced damping effect (2.4.A.3b)

Front Brake pad(s) close to minimum limit (3.2.A1f(i))

Exhaust mounting does not fully support the exhaust system (7.1.1.c)

Front Brake lever has inadequate reserve travel (3.1.3b)

Rear Stop lamp remains on when the brake is released (1.3.1e)

Registration plate with character(s) which are not the correct width (6.3.4a)

Front Brake pad(s) close to minimum limit (3.2.A1f(i))

Drive chain excessively loose (6.2.1d)

Rear Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Front Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Front position lamp does not illuminate immediately when switched on (1.1.3a)

Rear Brake master cylinder has a seized master cylinder pivot. (3.2.B5)

Rear shock absorber has inadequate damping effect. (2.4.A.3b)

Roller brake test The less effective brake control does not achieve an efficiency of 25%. (3.3.A2b)

Front Brake pad(s) close to minimum limit (3.2A1f(ii))

Wheel alignment slightly misaligned. (2.5.1)

Rear Stop lamp does not illuminate immediately a brake applies (1.3.1a)