1999 Rover 420

Nearside Headlamp aim too low (1.8)

Nearside Rear Anti-roll bar has excessive play in a pin/bush (2.4.G.2)

Nearside Rear Body has a sharp edge caused by corrosion (6.1.C.1)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside rear brake recording little or no effort (3.7.B.5a)

Offside Headlamp aim too low (1.8)

Offside Rear Body has a sharp edge caused by corrosion (6.1.C.1)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Windscreen has damage to the swept area in excess of a 40mm circle outside zone 'A' (8.3.1d)

Nearside Rear Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Offside Rear Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

nearside front tyre worn on outer edge

Nearside Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Registration plate lamp not working (1.1.5c)

Offside Front constant velocity joint gaiter deteriorated (2.5.C.1a)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

plastic covers on outer sills

Nearside Headlamp not working on dipped beam (1.7.5a)

Nearside Rear Direction indicator incorrect colour (1.4.A.2f)

Nearside Steering pivot point has excessive play (2.2.B.1g)

Offside Headlamp not in good working order adversely affecting beam image (1.2.4a)

Offside Rear Direction indicator incorrect colour (1.4.A.2f)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)