1999 Subaru Forester

Brake pipe corroded, covered in grease or other material All including ferrules (1.1.11 (c))

General underbody corrosion - however underbody has been undersealed

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Suspension lowered

Brake hose has slight corrosion to ferrule all 4 (1.1.12 (f) (i))

Brake hose slightly deteriorated all 4 (1.1.12 (b) (ii))

Brake pipe clips or supports missing, pipe adequately supported (1.1.11 (d) (i))

Front Macpherson strut mounting modified but not seriously weakened (5.3.3 (c) (i))

Front Suspension component modified but not seriously weakened (5.3.3 (c) (i))

Nearside Rear Lower Suspension arm attachment bracket/mounting damaged but its strength is not seriously reduced (5.3.3 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Suspension component modified but not seriously weakened (5.3.3 (c) (i))

Rear Vehicle structure is corroded but structural rigidity is not significantly reduced both sides inner sill area (6.1.1 (c) (i))

under body areas heavily under sealed

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Exhaust carbon monoxide content at idle exceeds default limits (8.2.1.2 (b))

Nearside Rear Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))

Nearside Rear Anti-roll bar pin or bush excessively worn d-bush (5.3.4 (a) (i))

Nearside Rear Outer Suspension arm insecurely attached both arms loose, bolt needs to be tightened (5.3.3 (a) (i))

Offside Rear Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))

Offside Rear Lower Suspension component mounting prescribed area excessively corroded significantly reducing structural strength within wheel arch next to outer sill (5.3.6 (a) (i))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Road wheel fixing missing 4) missing one from each wheel (5.2.1 (a) (i))

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Registration plate lamp missing in the case of multiple lamps or light sources (4.7.1 (b) (i))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Front Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Rear Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Nearside Rear Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Offside Rear Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Lower Suspension component ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Front Position lamp incorrect colour (4.2.3 (a) (i))

Sound deadening material not fully secure (8.1.1 (b) (i))

Rear rear roll bar corroded

slight leak at exhoust sistem

All 4 tyres perished

Rear Subframe mounts rusty

Unable to check outer sills fully plastic covers fitted

Nearside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Nearside Steering rack gaiter split (2.2.D.2d)

Offside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Offside Steering rack gaiter split (2.2.D.2d)

All 4 tyres perished

Rear Subframe mounts rusty

Unable to check outer sills fully plastic covers fitted

Brake pad(s) wearing thin (3.5.1g)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Offside Front Seat belt damaged sufficient to obstruct correct operation of the belt (5.2.2a)

Rear fog lamp not working (1.3.2b)

Registration plate lamp not working (1.1.C.1d)

Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Brake pad(s) wearing thin (3.5.1g)

Front Tyre worn close to the legal limit (4.1.E.1)

Exhaust has a minor leak of exhaust gases (7.1.2)

Exhaust has a minor leak of exhaust gases (7.1.2)