2003 Triumph Daytona

Horn slightly loose (7.7 (b))

Rear Brake disc worn, but not excessively (1.1.14 (a) (i))

Rear Lower Suspension pin, bush or joint worn but not resulting in excessive movement (5.3.4 (a) (i))

Registration plate deteriorated but not likely to be misread (0.1 (b))

Front Brake effort inadequate at a wheel (1.2.1 (a) (i))

Front Brake lever has insufficient reserve travel (1.1.2 (a))

Steering headbearing excessively stiff or notchy (2.2.2 (f) (i))

Horn slightly loose (7.7 (b))

Rear Lower Suspension pin, bush or joint worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Front Wheel bearing has excessive play (5.1.3 (a) (i))

Nearside Front Headlamp not working on main beam (4.1.1 (a) (ii))

Steering operation linkage fouling when handlebars turned from lock to lock engine cuts out when steering turned (2.1.4 (a))

Front Wheel bearing so rough it is likely to overheat or break up (5.1.3 (b) (ii)) DANGEROUS

Drive chain slightly tight (6.1.7 (k) (i))

Front Brake indicates slight fluctuation of brake effort (1.2.1 (e))

Front Wheel bearing has slight play (5.1.3 (a) (i))

Drive chain slightly tight (6.1.7 (k) (i))

Front Brake indicates slight fluctuation of brake effort (1.2.1 (e))

Front Wheel bearing has slight play (5.1.3 (a) (i))

Throttle operating incorrectly (6.2.7 (a) (i))

Clutch lever bent (6.2.1g)

Front Brake lever is bent but brake can still be readily applied (3.1.3c)

Front Roller brake test indicates slight fluctuation of brake effort (3.3.A1d)

Front Brake lever is bent but brake can still be readily applied (3.1.3c)

MIL Light on

front and rear brake discs corroded

headlamp lens damaged

Front Brake lever is bent but brake can still be readily applied (3.1.3c)

Steering movement excessively stiff with the weight on the lower bearing (2.2.1a)

Front Brake lever is bent but brake can still be readily applied (3.1.3c)

Front Front wheel bearings have excessive free play (2.3.5b)

Front Direction indicator not working (1.5.1c)

Front Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))