1999 Aprilia RS 50

Wheel alignment slightly misaligned (2.4 (a))

Registration plate insecure (6.3.1b)

Front Front mudguard insecure (2.3.7)

Front shock absorber seal failed and leaking oil (2.3.3)

Handlebar cracked (2.1.1b)

Fairings insecure but not likely to impede the steering (2.1.2e)

Rear Tyre worn close to the legal limit (4.1.3(ii))

Front Stop lamp missing (1.3.3a)

Headlamp at least one does not illuminate on main beam (1.2.2a(ii))

Nearside Front shock absorber seal failed and leaking oil (2.3.3)

Nearside Rear Direction indicator insecure (1.5.3b)

Offside Front shock absorber seal failed and leaking oil (2.3.3)

Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Brake pedal is bent but brake can still be readily applied (3.1.3c)

Drive chain slightly loose (6.2.1d)

Rear wheel bearings have slight free play (2.4.A.2c)

Exhaust noisy (7.1.2)

Rear Brake pad(s) close to minimum limit (3.2.A1f(i))

Headlamp aim too high (1.6)

Steering control handlebar movement restricted by trapped cables (2.1.2c)

Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Throttle operating incorrectly (6.2.1f)

Exhaust noisy (7.1.2)

Rear Brake pad(s) close to minimum limit (3.2.A1f(i))

please re route the electrical and mechanical cables correctly around the headstock

Brake pedal is damaged and the brake cannot be readily applied (3.1.3c)

Front Brake lever is bent and the brake cannot be readily applied (3.1.3c)

Headlamp aim headlamp deteriorated and function impaired (1.2.3a)

Nearside Rear Footrest missing (6.2.1a)

Offside Rear Footrest missing (6.2.1a)

Rear position lamp does not illuminate immediately when it is switched on (1.1.3a)

Rear shock absorber has inadequate damping effect. (2.4.A.3b)

Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Rear shock absorber insecurely mounted (2.4.A.3b) DANGEROUS

Exhaust noisy (7.1.2)

motorcycle in poor general condition

Fuel system component insecure (7.2.1b)

Offside Front Direction indicator not working (1.5.1c)

Drive chain worn but not considered excessive (6.2.1e)

Rear Brake pad(s) close to minimum limit (3.2.A1f(i))

Rear Drive chain sprocket slightly worn (6.2.1e)

slight play in rear lower swinging arm mounting bushes † †slight roughness to front wgeel bearing † †slight damage to front flexi brake hose

Front Headlamp aim too high (hotspot upper edge above the horizontal 0% line) (1.6.1)

Front Steering headbearing has excessive free play (2.2.2)

Nearside Front Front shock absorber seal failed and leaking oil (2.3.3)

chain too tight and adjuster bolt not touching adjuster.

Front Headlamp aim too high when the centre of the headlamp is below 850mm from the ground (1.6.2)

Front Headlamp insecure (1.2.3b)

Steering headbearing has slight free play (2.2.2)