MOT Status
ExpiredMileage
121,100 miSignificantly above average — investigate
Not all car check providers offer a guarantee. Don't risk buying from services that can't back their data. CarVerify reports include a £30,000 finance data guarantee.
Vehicle Details
All premium checks include
50+ data pointsMOT History
Nearside Headlamp lens slightly defective (4.1.1 (b) (i))
Offside Headlamp lens slightly defective (4.1.1 (b) (i))
Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))
Fuel system component leaking Tank area (6.1.3 (b) (i))
Nearside Front Position lamp not working (4.2.1 (a) (ii))
Offside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced (7.1.1 (a) (i))
Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))
Offside Stop lamp(s) not working (4.3.1 (a) (ii))
Nearside Headlamp lens slightly defective (4.1.1 (b) (i))
Nearside Non obligatory mirror damaged ()
Offside Headlamp lens slightly defective (4.1.1 (b) (i))
Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))
Central Brake pipe corroded, covered in grease or other material (1.1.11 (c))
Offside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))
Oil leak, but not excessive (8.4.1 (a) (i))
Rear Shock absorbers light misting of oil or has limited damping effect both sides (5.3.2 (b))
Supplementary restraint system warning lamp does not illuminate (7.1.6 (a))
Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))
Headlamp light intensity severely reduced both (4.1.4 (a))
Nearside Front Lower Suspension component mounting prescribed area excessively corroded significantly reducing structural strength floor area (5.3.6 (a) (i))
Offside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill area (5.3.6 (a) (i))
Rear Exhaust emissions likely to be affected by an exhaust leak (8.2.1.1 (b))
Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))
Windscreen washer provides insufficient washer liquid (3.5 (a))
Central Brake pipe corroded, covered in grease or other material (1.1.11 (c))
Offside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))
Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))
Oil leak, but not excessive (8.4.1 (a) (i))
Rear Shock absorbers light misting of oil or has limited damping effect both sides (5.3.2 (b))
Headlamp deteriorated but light output not reduced both (1.7.5a)
Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive floor area (2.4.A.3)
Offside Front Shock absorber has a light misting of oil (2.7.3)
Offside Front Suspension component mounting prescribed area is corroded but not considered excessive floor area (2.4.A.3)
Nearside Front Outer Suspension component mounting prescribed area is excessively corroded sill area (2.4.A.3)
Nearside Rear Inner Seat belt anchorage prescribed area is excessively corroded wheel arch area (5.2.6)
Nearside Rear Outer Suspension component mounting prescribed area is excessively corroded sill area (2.4.A.3)
Nearside Windscreen washer provides insufficient washer liquid (8.2.3)
Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)
Offside Front position lamp(s) not working (1.1.A.3b)
Offside Rear Inner Seat belt anchorage prescribed area is excessively corroded wheel arch area (5.2.6)
Offside Rear Inner Suspension component mounting prescribed area is excessively corroded and outer sill area (2.4.A.3)
Offside Registration plate lamp not working (1.1.C.1d)
Headlamp deteriorated but light output not reduced both (1.7.5a)
Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive floor area (2.4.A.3)
Offside Front Shock absorber has a light misting of oil (2.7.3)
Offside Front Suspension component mounting prescribed area is corroded but not considered excessive floor area (2.4.A.3)
Offside Front Tyre worn close to the legal limit (4.1.E.1)
Nearside Front position lamp(s) not working (1.1.A.3b)
Offside Front Tyre worn close to the legal limit (4.1.E.1)
Anti-lock braking system warning lamp indicates an ABS fault (3.4.1c)
Centre Exhaust system not adequately supported (7.1.1)
Front Brake pad(s) less than 1.5 mm thick (3.5.1g)
Front Windscreen wiper does not clear the windscreen effectively (8.2.2)
Nearside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)
Nearside Rear position lamp(s) not working (1.1.A.3b)
Offside Headlamp aim too high (1.8)
Parking brake: efficiency below requirements (3.7.B.7)
Offside Front Tyre worn close to the legal limit (4.1.E.1)
Front Brake pad(s) wearing thin (3.5.1g)
Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)
Nearside Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)
Offside Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)
Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)
Nearside Radius arm rubber bush bonding deteriorated resulting in excessive movement (2.4.G.2)
Offside rear parking brake recording little or no effort (3.7.B.6a)
Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)
Front Brake pad(s) wearing thin (3.5.1g)
Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)
Nearside Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)
Offside Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)
Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)
Brake pipe slightly corroded (3.6.B.2c)
Offside Front Brake pipe slightly corroded (3.6.B.2c)
Oil leak
Rear Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)
Nearside Front constant velocity joint gaiter insecure to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)
Nearside Stop lamp not working (1.2.1b)
Offside Front constant velocity joint gaiter insecure to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)
Offside rear parking brake recording little or no effort (3.7.B.6a)
Parking brake: efficiency below requirements (3.7.B.7)
Nearside Front Brake hose has slight corrosion to ferrules (3.6.B.4e)
Nearside Front Vehicle structure has slight corrosion (6.1.A.1)
Nearside Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)
Nearside Rear Trailing arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)
Offside Front Brake hose has slight corrosion to ferrules (3.6.B.4e)
Offside Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)
front and rear suspension arms corroded
Nearside Rear brake disc excessively pitted (3.5.1h)
Offside Rear brake disc excessively pitted (3.5.1h)
Parking brake: efficiency below requirements (3.7.B.7)
Bolt missing off side front brake flex hose mount bracket
Rear Brake pad(s) wearing thin (3.5.1g)
Nearside Outer Front constant velocity joint gaiter split (2.5.C.1a)
Offside Outer Front constant velocity joint gaiter split (2.5.C.1a)
Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)
Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)
Exhaust emissions hydrocarbon content after 2nd fast idle excessive (7.3.D.3)
Nearside Rear rear parking brake recording little or no effort (3.7.B.6a)
Offside Rear rear parking brake recording little or no effort (3.7.B.6a)
Parking brake: efficiency below requirements (3.7.B.7)
light binding on all wheels
Nearside Front Front constant velocity joint gaiter split (2.5.C.1a)
Offside Front Front constant velocity joint gaiter split (2.5.C.1a)
Parking brake: efficiency below requirements (3.7.B.7)
How Reliable is the Honda Civic?
Based on 9,391,580 MOT tests across 693,715 vehicles.
Top MOT Failure Points
Don't risk it. Know before you buy.
Not all vehicle check providers are the same. Some don't offer a data guarantee, which means if their information is wrong, you're on your own. Every CarVerify report is backed by a £30,000 finance data guarantee.
T717 DLW is a 1999 Honda Civic in Green with a 1,590cc petrol engine. This vehicle has been through 25 MOT tests with a personal pass rate of 56%.
Across all 1999 Honda Civic models, the average MOT pass rate is 68.5% with a typical mileage of 78,715 miles. This particular vehicle has a lower pass rate than the average for its year, which may indicate maintenance issues worth investigating.
The most common reason a Honda Civic fails its MOT is tyre tread depth below requirements of 1.6mm, accounting for 307,913 recorded failures. If you're considering buying T717 DLW, it's worth having these areas checked by a mechanic before committing.
The Honda Civic typically stays on UK roads for around 34 years. At 27 years old, this Honda Civic is well into its expected lifespan but still has years ahead.
Frequently Asked Questions
How do I check the history of T717 DLW?
You can check the full history of T717 DLW by running a full vehicle check. This shows you finance, stolen, write-off, MOT history, mileage records and more.
What year was T717 DLW registered?
T717 DLW is a 1999 Honda Civic, first registered on 27 April 1999.
Is T717 DLW safe to buy?
The MOT history for T717 DLW shows 25 tests with a 56% pass rate. To check for outstanding finance, stolen markers, write-off history and mileage discrepancies, run a full vehicle check.
Does T717 DLW have outstanding finance?
Finance checks require a premium vehicle report. This checks against all major UK finance providers to see if there is any outstanding finance on T717 DLW. If you buy a car with outstanding finance, the finance company can repossess it.
No warranty or guarantee of accuracy is provided for any free data on this page. The data guarantee applies only to information obtained through the purchase of a full check.