1999 Honda Integra

Nearside Front Service brake binding but not excessively (1.2.1 (f))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Exhaust carbon monoxide content at idle exceeds default limits (8.2.1.2 (b))

Nearside Front Service brake excessively binding (1.2.1 (f))

Nearside Rear Service brake lagging in operation (1.2.1 (d))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Coolant leak ()

Nearside Headlamp aim too low (4.1.2 (a))

Nearside Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Headlamp aim too low (4.1.2 (a))

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Offside Rear Direction indicator not working (4.4.1 (a) (ii))

Suspension component mounting prescribed area excessively corroded significantly reducing structural strength both rear inner wings at rear of sills (5.3.6 (a) (i))

Windscreen washer not working (3.5 (a))

seal covers fitted

Anti-lock braking system warning lamp indicates an ABS fault (3.4.1c)

Offside Rear Suspension component mounting prescribed area is excessively corroded rear trailing arm mounting (2.4.A.3)

Nearside Rear Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Offside Rear Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Oil leak

Nearside Rear Registration plate lamp not fitted (1.1.C.1b)

Nearside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Front Headlamp aim too low (1.8)

Offside Rear Registration plate lamp not fitted (1.1.C.1b)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a) DANGEROUS

Oil leak

Offside Front Brake pad(s) wearing thin (3.5.1g)

both rear brake discs corroded but meet mot requirements.

engine has various oil leaks.

Nearside Rear Rear wheel bearing has excessive play (2.6.2)

Offside Front Brake pad(s) wearing thin (3.5.1g)

both rear brake discs corroded but meet mot requirements.

engine has various oil leaks.

Headlamp aim too high (1.8)

both front tyres worn close to legal minimum of 1.6mm

covers on outer sills

offside rear brake disc corroded

surface corrosion around rear suspension mountings

both front tyres worn close to legal minimum of 1.6mm

covers on outer sills

offside rear brake disc corroded

surface corrosion around rear suspension mountings

Nearside Rear wheel bearing has slight play (2.6.2)

Nearside Rear wheel bearing has slight play (2.6.2)

Offside Steering locking device missing (2.2.C.1g)

Emissions not tested (7.0)

Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Rear Trailing arm rubber bush bonding deteriorated resulting in excessive movement (2.4.G.2)

Nearside Rear wheel bearing rough when rotated (2.6.1)

Nearside Side repeater not working (1.4.A.2c)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front wheel bearing rough when rotated (2.5.A.2)

Offside Rear Trailing arm rubber bush bonding deteriorated resulting in excessive movement (2.4.G.2)

Offside Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7) DANGEROUS

centre exhaust mounting rubbers deteriated

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front position lamp(s) not working (1.1.A.3b)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

brake disc slightly pitted (3.5.1h)

Nearside Rear brake disc slightly pitted (3.5.1h)

Offside Rear brake disc slightly pitted (3.5.1h)