1999 Honda Civic

Integral body structure is corroded but structural rigidity is not significantly reduced underside (6.1.1 (c) (i))

Offside Front Steering rack gaiter missing or no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Integral body structure is corroded but structural rigidity is not significantly reduced underside (6.1.1 (c) (i))

Nearside Front Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Nearside Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Rear bumper iron corroded

Front Brake hose has slight corrosion to ferrule x 2 (1.1.12 (f) (i))

Rear Brake hose has slight corrosion to ferrule x 2 (1.1.12 (f) (i))

front suspension has lots of surface corrosion

rear bumper support bracket corroded

rear suspension arms and bushes corroded

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Exhaust carbon monoxide content at idle exceeds default limits (8.2.1.2 (b))

Exhaust hydrocarbon content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Nearside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Front Lower Macpherson strut pin or bush worn but not resulting in excessive movement both (5.3.4 (a) (i))

Front Suspension arm corroded but not seriously weakened Both (5.3.3 (b) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Coil spring corroded both (5.3.1 (b) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive trailing arm mounts (5.3.6 (a) (i))

Both headlights deteriorating

Front Suspension component mounting prescribed area is corroded but not considered excessive both jacking point areas (5.3.6 (a) (i))

Nearside Front Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

O/s rear wing damaged

Offside Front Tyre worn close to legal limit/worn on edge inside edge (5.2.3 (e))

Rear Suspension component mounting prescribed area is corroded but not considered excessive both rear of floor (5.3.6 (a) (i))

Area around front jacking points going rusty also plastic outer sill covers fitted

Headlights deteriorating

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Area around front jacking points going rusty also plastic outer sill covers fitted

Headlights deteriorating

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e))

Front Brake pad(s) wearing thin (3.5.1g)

Front Subframe mounting prescribed area is corroded but not considered excessive [near jacking points] (2.4.A.3)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Rear Brake pipe slightly corroded (3.6.B.2c)

Front Brake pad(s) wearing thin (3.5.1g)

Front Suspension component mounting prescribed area is corroded but not considered excessive both, jacking points (2.4.A.3)

Rear Brake pipe slightly corroded (3.6.B.2c)

Rear registration plate deteriorated but not likely to be misread (6.3.1d)

outer plastic sill covers are fitted

Front Brake pad(s) wearing thin (3.5.1g)

Front Suspension component mounting prescribed area is corroded but not considered excessive both, jacking points (2.4.A.3)

Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Rear Brake pipe slightly corroded (3.6.B.2c)

Rear registration plate deteriorated but not likely to be misread (6.3.1d)

outer plastic sill covers are fitted

Area around front jacking points going rusty

Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Area around front jacking points going rusty

Rear Brake pipe slightly corroded (3.6.B.2c)

Front Brake pad(s) wearing thin (3.5.1g)

Front Suspension arm corroded but not seriously weakened (2.4.G.1)

Nail in offside rear tyre

Plastic sill cover are fitted.

Front Suspension arm corroded but not seriously weakened (2.4.G.1)

Plastic sill covers are fitted..

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Under-trays fitted obscuring some underside components

n/s/f wiper blade rubber is splitting.

Centre and rear exhaust sections are going rusty.

Inside edge of rear tyres are wearing.

Plasic sill covers fitted.

Both rear tyre side walls are cracking.

Plastic side sill covers are fitted and so not allowing full inspection of outer sills.

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

advise o/s/rear and n/s/ rear tyre wall

advise sill covers fitted

Exhaust has part of the system slightly deteriorated (7.1.1a)

advise both rear tyres slightly de-formed & cracked between tread advise replace