1999 Chrysler Grand Voyager

Brake pipe corroded, covered in grease or other material From Centre all the way back. (1.1.11 (c))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Front Track rod end ball joint has slight play (2.1.3 (b) (i))

Offside Front Tyre worn close to legal limit/worn on edge worn on edge (5.2.3 (e))

Battery insecure and likely to cause a short circuit (4.13 (a) (ii))

Nearside Front Macpherson strut corroded and seriously weakened (5.3.3 (b) (i))

Nearside Front Road wheel fixing missing (5.2.1 (a) (i))

Nearside Rear Road wheel fixing missing (5.2.1 (a) (i))

Nearside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced Outer sill x2. (7.1.1 (a) (i))

Offside Front Road wheel fixing missing (5.2.1 (a) (i))

Offside Rear Road wheel fixing missing (5.2.1 (a) (i))

Offside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced Outer sill. (7.1.1 (a) (i))

Offside Side repeater not working (4.4.1 (a) (ii))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Brake pipe corroded, covered in grease or other material From Centre all the way back. (1.1.11 (c))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Front Track rod end ball joint has slight play (2.1.3 (b) (i))

Offside Front Tyre worn close to legal limit/worn on edge worn on edge (5.2.3 (e))

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Headlamp has a product on the lens but not seriously reducing light output both front (4.1.4 (b))

Offside Rear & both rear seat missing

Oil leak, but not excessive (8.4.1 (a) (i))

one wheel nut missing from each wheel

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

Nearside Rear Service brake has no recorded effort at a wheel (1.2.1 (a) (ii)) DANGEROUS

Nearside Rear Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected outer sill (5.3.6 (a) (ii)) DANGEROUS

Offside Rear Inner Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected wheel arch (5.3.6 (a) (ii)) DANGEROUS

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Headlamp has a product on the lens but not seriously reducing light output both front (4.1.4 (b))

Offside Rear & both rear seat missing

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front Suspension arm ball joint has slight play and offside front (5.3.4 (a) (i))

Brake pipe slightly corroded (3.6.B.2c)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

headlamps deteriorated image just passable

rear foot and handbrake effort low

Nearside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Offside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Service brake: efficiency below requirements (3.7.B.7) DANGEROUS

both front headlamp glasses faded lenses

Brake pipe slightly corroded (3.6.B.2c)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Front Anti-roll bar linkage damaged and seriously weakened (2.4.G.1)

Offside Front Brake pipe excessively corroded (3.6.B.2c)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Brake pipe slightly corroded (3.6.B.2c)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

O/s/f tyre has slight cracking

Front Brake pipe slightly corroded (3.6.B.2c)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Rear position lamp(s) excessively deteriorated so that it is not visible from a reasonable distance (1.1.A.3d)

Rear Registration plate lamp not illuminating the registration plate (1.1.C.1e)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)