2003 Lexus IS200

Child Seat fitted not allowing full inspection of adult belt

Nearside Rear Wheel arch corroded

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Child Seat fitted not allowing full inspection of adult belt

Nearside Rear Wheel arch corroded

Oil leak, but not excessive (8.4.1 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Oil leak, but not excessive (8.4.1 (a) (i))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust catalytic converter missing where one was fitted as standard (8.2.1.1 (a))

Exhaust hydrocarbon content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Exhaust noisy (8.1.1 (a))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside front and rear sill damage

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside front and rear sill damage

some underside components covered

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Electronic stability control warning lamp indicates a fault (7.12 (e))

Nearside Headlamp aim too low (4.1.2 (a))

Nearside Rear Brake pipe excessively corroded (1.1.11 (c))

Offside Headlamp aim too low (4.1.2 (a))

Offside Rear Upper Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside front and rear sill damage

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside front and rear sill damage

some underside components covered

Electrical wiring inadequately secured sub and wiring in boot (4.11 (a) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Electrical wiring inadequately secured sub and wiring in boot (4.11 (a) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

lift to o/s/f lower ball joint

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear Sub-frame rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Sub-frame rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Anti-lock braking system warning lamp indicates an ABS fault (3.4.1c)

Front Brakes imbalanced across an axle (3.7.B.5b)

Front Rear position lamp(s) not working (1.1.A.3b)

Horn not working (1.6.2a)

Nearside Rear Tyre tread depth below requirements of 1.6mm inner edge (4.1.E.1)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Front front brake binding (3.7.B.1)

Offside Headlamp not working on dipped beam (1.7.5a)

Offside Rear Rear position lamp(s) not working (1.1.A.3b)

Service brake: efficiency below requirements (3.7.B.7)

Nearside Front Front wheel bearing has excessive play Bearing collapsed damaging brake caliper (2.5.A.3c) DANGEROUS

engine management and traction control warning lamps showing

Nearside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Offside Front Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Offside Front wheel bearing has excessive play (2.5.A.3c)

Offside Headlamp not working on dipped beam (1.7.5a)

Offside Front Headlamp aim beam image obviously incorrect (1.8.A.1b)

Rear Registration plate lamp not working (1.1.C.1d)

Windscreen washer provides insufficient washer liquid (8.2.3)

Front Shock absorber has a serious fluid leak (2.7.3)

Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Fuel pipe/s corroded

Suspension joint offside lower dust cover split/missing