1999 Honda Accord

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Nearside Front Inner Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Nearside Headlamp aim too low (4.1.2 (a))

Offside Front Inner Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Offside Headlamp aim too low (4.1.2 (a))

Offside Inner Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced seat belt anchorage (6.1.1 (c) (i))

Windscreen washer provides insufficient washer liquid (3.5 (a))

Nearside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

surface corrosion throughout under side

Nearside Front Tyre slightly damaged/cracking or perishing inner wall slight bulges (5.2.3 (d) (ii))

Nearside Front side repeater turning white

Offside Front Headlamp lens slightly defective poor beam pattern (4.1.1 (b) (i))

Offside Front side repeater turning white

Central Rear Exhaust emissions likely to be affected by an exhaust leak middle and rear sections holed and blowing (8.2.1.1 (b))

Emissions not tested (8.2.2.2 (e))

Nearside Front Tyre slightly damaged/cracking or perishing inner wall slight bulges (5.2.3 (d) (ii))

Nearside Front side repeater turning white

Offside Front Headlamp lens slightly defective poor beam pattern (4.1.1 (b) (i))

Offside Front side repeater turning white

Front Windscreen washer not working (3.5 (a))

Offside Front Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting chalk marked (floor pan near drain hole ) (6.2.2 (d) (i))

Offside Front Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting chalk marked (near jacking point) (6.2.2 (d) (i))

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive under arch (5.3.6 (a) (i))

Nearside Front Vehicle structure is corroded but structural rigidity is not significantly reduced chassis just behind subframe (6.1.1 (c) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Brake pipe inadequately clipped or supported also runs along bulk head area (1.1.11 (d) (i))

Offside Front Vehicle structure is corroded but structural rigidity is not significantly reduced chassis just behind subframe (6.1.1 (c) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength under arch (5.3.6 (a) (i))

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive under arch (5.3.6 (a) (i))

Nearside Front Vehicle structure is corroded but structural rigidity is not significantly reduced chassis just behind subframe (6.1.1 (c) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Brake pipe inadequately clipped or supported also runs along bulk head area (1.1.11 (d) (i))

Offside Front Vehicle structure is corroded but structural rigidity is not significantly reduced chassis just behind subframe (6.1.1 (c) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Offside Rear Anti-roll bar ball joint excessively worn (5.3.4 (a) (i))

Offside Front Anti-roll bar ball joint excessively worn (5.3.4 (a) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive inner wing slight corrision (2.4.A.3)

Offside Rear Braking system leaking (3.6.A.1)

Offside Headlamp aim too high and too far to the right. (1.8)

Nearside Rear Direction indicator slightly discoloured (1.4.A.2f)

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Direction indicator slightly discoloured (1.4.A.2f)

Rear Anti-roll bar corroded but not seriously weakened (2.4.G.1)

brake pipes greased

Nearside Front Direction indicator incorrect colour (1.4.A.2f)

Offside Front Direction indicator incorrect colour (1.4.A.2f)

Offside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Offside Headlamp excessively deteriorated so that the light output is severely reduced (1.7.5a)

Nearside Rear Direction indicator slightly discoloured (1.4.A.2f)

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Direction indicator slightly discoloured (1.4.A.2f)

Rear Anti-roll bar corroded but not seriously weakened (2.4.G.1)

brake pipes greased

Direction indicator slightly discoloured (1.4.A.2f)

Exhaust has a minor leak of exhaust gases (7.1.2)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Stop lamp not working (1.2.1b)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)