2003 Subaru Impreza

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Offside Front Vehicle structure is corroded but structural rigidity is not significantly reduced inner sill (6.1.1 (c) (i))

Offside Rear Tyre worn close to legal limit/worn on edge 3mm (5.2.3 (e))

Offside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Exhaust catalytic converter missing where one was fitted as standard (8.2.1.1 (a))

Exhaust hydrocarbon content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Nearside Front Road wheel fixing missing nut missing (5.2.1 (a) (i))

Nearside Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Engine management light is on

Nearside Inner Seat belt anchorage prescribed area is corroded but not considered excessive sill (7.1.1 (a) (i))

Offside Rear Inner Seat belt anchorage prescribed area is corroded but not considered excessive sill (7.1.1 (a) (i))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

sill covers fitted

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Passenger seat(s) missing at time of test ()

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Headlamp aim too low (4.1.2 (a))

Offside Headlamp aim too high (4.1.2 (a))

Passenger seat(s) missing at time of test ()

Nearside Rear Anti-roll bar linkage insecurely attached (5.3.3 (a) (i))

Nearside Rear Lower Suspension component mounting prescribed area excessively corroded significantly reducing structural strength front of inner wheel arch (5.3.6 (a) (i))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Rear Lower Suspension component mounting prescribed area excessively corroded significantly reducing structural strength front of inner wheel arch (5.3.6 (a) (i))

Windscreen washer not working (3.5 (a))

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Passenger seat(s) missing at time of test ()

Seat belt anchorage prescribed area is corroded but not considered excessive o/s and n/s (7.1.1 (a) (i))

rear sub frame and suspension arms corroded

Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Anti-roll bar linkage ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Offside Front Anti-roll bar linkage ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Front Front suspension ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Offside Front Inner Front constant velocity joint gaiter damaged, but preventing the ingress of dirt (2.5.C.1a)

Rear Sub-frame corroded but not seriously weakened (2.4.G.1)