2007 Peugeot 107

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Rear Brake pipe excessively corroded (1.1.11 (c))

Offside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Rear Service brake excessively binding (1.2.1 (f))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Nearside Front Upper Macpherson strut mounting likely to fail (5.3.3 (b) (ii)) DANGEROUS

Offside Rear Brake pipe leaking on a hydraulic braking system (1.1.11 (b) (ii)) DANGEROUS

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

n/s/f wing mirror deteriorated

Nearside Brake pipe corroded, covered in grease or other material Front to rear (1.1.11 (c))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Brake pipe corroded, covered in grease or other material Front to rear (1.1.11 (c))

Nearside Front Steering locking device missing Track rod end (2.1.3 (d))

Offside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Nearside Brake pipe corroded, covered in grease or other material Front to rear (1.1.11 (c))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Brake pipe corroded, covered in grease or other material Front to rear (1.1.11 (c))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Brake lever has insufficient reserve travel (1.1.2 (a))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Front Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))

Nearside Front Position lamp not working (4.2.1 (a))

Nearside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Nearside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Nearside Rear Wheel bearing rough when rotated (5.1.3 (b) (i))

Nearside Registration plate lamp does not illuminate simultaneously with the position lamps (4.7.2 (a))

Offside Front Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))

Offside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Parking (secondary brake) on a single line braking system has inadequate effort at a wheel both rears (1.3.1 (a) (i))

Offside Front Tyre tread depth below requirements of 1.6mm inner tread (5.2.3 (e)) DANGEROUS

Offside Front Wheel bearing so rough it is likely to overheat or break up (5.1.3 (b) (ii)) DANGEROUS

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Macpherson strut corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Macpherson strut corroded but not seriously weakened (5.3.3 (b) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Oil leak, but not excessive (8.4.1 (a) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Front Wheel bearing rough when rotated (5.1.3 (b) (i))

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Registration plate lamp inoperative in the case of a single lamp or all lamps both (4.7.1 (b) (ii))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Offside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

eml on

Exhaust system not adequately supported front and rear (7.1.1)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Stop lamp not working (1.2.1b)

Offside Front position lamp(s) not working (1.1.A.3b)

eml on

slight stiffness in rotation at offside front wheel

Front brake disc in such a condition that it is seriously weakened (3.5.1i)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)