1980 Austin Morris Mini Clubman

Nearside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Front Service brake imbalanced across an axle (1.2.1 (b) (i))

Horn not working (7.7 (a))

Nearside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Front Service brake excessively binding (1.2.1 (f))

Offside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced Sill subframe point (6.1.1 (c) (i))

Offside Rear Service brake excessively binding (1.2.1 (f))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Exhaust mounting defective (6.1.2 (a))

Exhaust mounting defective (6.1.2 (a))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Rear Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Direction indicators flashing less than 60 times a minute (1.4.A.2g)

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Exhaust emissions hydrocarbon content excessive (7.3.B.1b)

Front Body has a sharp edge caused by corrosion (6.1.C.1)

Horn not working (1.6.2a)

Nearside Front Direction indicator not working (1.4.A.2c)

Nearside Front Front position lamp(s) not working (1.1.A.3b)

Nearside Front Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Front Upper Sub-frame rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Body has a sharp edge caused by corrosion (6.1.C.1)

Offside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Front Brake pipe excessively corroded (3.6.B.2c)

Offside Outer Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Rear rear brake recording little or no effort (3.7.B.5a)

Offside Rear rear parking brake recording little or no effort (3.7.B.6a)

Parking brake lever has no reserve travel (3.1.6b)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Brake pipe excessively corroded (3.6.B.2c)

Rear Sub-frame corroded and seriously weakened (2.4.G.1)

Body has slight corrosion (6.1.B.2)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Centre Brake cable has wires broken and is significantly weakened (3.5.1b)

Offside Outer Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Outer Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Body has slight corrosion (6.1.B.2)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Front Front position lamp(s) not working (1.1.A.3b)

Nearside Rear Body has a sharp edge caused by corrosion (6.1.C.1)

Offside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Rear Body has a sharp edge caused by corrosion (6.1.C.1)

Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Rear rear brake recording little or no effort (3.7.B.5a)

Service brake: efficiency below requirements (3.7.B.7)

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Exhaust engine idle speed too high (7.3.A.2a)

Nearside Front Headlamp aim too high (hotspot upper edge above the horizontal 0% line) (1.6.D1)

Nearside Front Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Rear Mechanical brake component has restricted free movement (3.5.1k)

Offside Front Headlamp aim too high (hotspot upper edge above the horizontal 0% line) (1.6.D1)

Offside Front Upper Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Front Windscreen washer provides insufficient washer liquid (8.2.3)

Parking brake: efficiency below requirements (3.7.B.7)

Service brake: efficiency below requirements (3.7.B.7)