2003 Fiat Ducato

Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Suspension component mounting repair covered in underseal (5.3.6 (a) (i))

Nearside Front Lower Suspension component mounting prescribed area excessively corroded significantly reducing structural strength chassis/ inner wing (5.3.6 (a) (i))

Nearside Front Wheel bearing has excessive play (5.1.3 (a) (i))

Offside Front Lower Steering linkage ball joint ball joint dust cover excessively damaged or deteriorated so that it no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Offside Front Lower Suspension component mounting prescribed area is inadequately repaired chassis/ inner wing (5.3.6 (a) (i))

Offside Headlamp aim too low (4.1.2 (a))

Brake pipe corroded, covered in grease or other material various (1.1.11 (c))

Offside Front Brake pipe inadequately clipped or supported mounting bracket where it joins flex pipe (1.1.11 (d) (i))

corrosion to o/s engine mounting area(chassis) not holed yet

repairs to o/s and n/s inner wings covered in underbody sealant

Front Suspension component mounting prescribed area excessively damaged significantly reducing structural strength both inner wings under wings (5.3.6 (a) (i))

Front Suspension component mounting prescribed area is corroded but not considered excessive both inner wings under wings (5.3.6 (a) (i))

Rear Tyre slightly damaged/cracking or perishing both (5.2.3 (d) (ii))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Outline marker lamp with a multiple light source more than 1/2 not functioning both sides (4.2.1 (a) (ii))

Rear Position lamp adversely affected by the operation of another lamp both sides (4.2.3 (c))

Stop lamp(s) not working (4.3.1 (a) (ii))

Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Front Suspension component mounting prescribed area is corroded but not considered excessive both inner wings under wings (5.3.6 (a) (i))

Rear Tyre slightly damaged/cracking or perishing both (5.2.3 (d) (ii))

Brake load sensing valve inoperative but ABS functioning (1.1.17 (c) (i))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner wing under wing (5.3.6 (a) (i))

Battery insecure and likely to cause a short circuit (4.13 (a) (ii))

Brake load sensing valve seized but ABS functioning (1.1.17 (c) (i))

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner wing (5.3.6 (a) (i))

Seat belt installation has a seat fitted to a flat rail and the mounting bolt not passing through the leg, rail, floor, and a suitable structural member both inner and outer steps (10.1 (p))

Windscreen wiper does not clear the windscreen effectively (8.2.2)

Brake load sensing valve linkage seized (3.6.E.3)

Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Tyre has a tear, caused by separation or partial failure of its structure (4.1.D.1b) DANGEROUS

exhaust cat rattle / all 4 tyres perishing /

baffles in exhaust rattling /