2007 Peugeot 107

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Front Wheel bearing rough when rotated (5.1.3 (b) (i))

Nearside Rear Wheel bearing rough when rotated (5.1.3 (b) (i))

Offside Front Wheel bearing rough when rotated (5.1.3 (b) (i))

Offside Rear Wheel bearing rough when rotated (5.1.3 (b) (i))

Registration plate lamp inoperative in the case of a single lamp or all lamps both (4.7.1 (b) (ii))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Headlamp lens slightly defective both (4.1.1 (b) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Wheel bearing has slight play (5.1.3 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Subframe mounting prescribed area is corroded but not considered excessive both sides (5.3.6 (a) (i))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Brake disc worn, pitted or scored, but not seriously weakened scored (1.1.14 (a) (ii))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust hydrocarbon content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Nearside Seat belt anchorage prescribed area strength or continuity significantly reduced middle floor to sill (7.1.1 (a) (i))

Offside Front Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Offside Rear Tyre has a tear, caused by separation or partial failure of its structure on sidewalls (5.2.3 (d) (ii)) DANGEROUS

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Brake disc worn, pitted or scored, but not seriously weakened scored (1.1.14 (a) (ii))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Tyre worn close to legal limit/worn on edge on outer edge (5.2.3 (e))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Subframe mounting prescribed area is corroded but not considered excessive both sides (5.3.6 (a) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive outer sills both sides (5.3.6 (a) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Rear Exhaust has a major leak of exhaust gases silencer (6.1.2 (a))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Tyre worn close to legal limit/worn on edge on outer edge (5.2.3 (e))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Subframe mounting prescribed area is corroded but not considered excessive both sides (5.3.6 (a) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive outer sills both sides (5.3.6 (a) (i))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear Subframe mounting prescribed area is corroded but not considered excessive both sides (5.3.6 (a) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive outer sills both sides (5.3.6 (a) (i))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear Subframe mounting prescribed area is corroded but not considered excessive both sides (5.3.6 (a) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive outer sills both sides (5.3.6 (a) (i))

Offside Front Tyre has ply or cords exposed (5.2.3 (d) (ii))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge on inner edge (5.2.3 (e))

Rear Subframe mounting prescribed area damaged but not considered excessive both sides (5.3.6 (a) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive outer sills both sides (5.3.6 (a) (i))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Offside Rear outer sill slight corrosion

Rear Subframe mounting prescribed area is corroded but not considered excessive both sides (5.3.6 (a) (i))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Offside Rear outer sill slight corrosion

Rear Subframe mounting prescribed area is corroded but not considered excessive both sides (5.3.6 (a) (i))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Front exhaust mounting bracket broken but exhaust still adequately supported

Offside Rear outer sill slight corrosion

Rear Subframe mounting prescribed area is corroded but not considered excessive both sides (5.3.6 (a) (i))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Front exhaust mounting bracket broken but exhaust still adequately supported

Nearside Rear Brake pipe corroded, covered in grease or other material to brake hose (1.1.11 (c))

Rear Subframe mounting prescribed area is corroded but not considered excessive both sides (5.3.6 (a) (i))

Rear Tyre slightly damaged/cracking or perishing both sides (5.2.3 (d) (ii))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Front exhaust mounting bracket broken but exhaust still adequately supported

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Brake pipe corroded, covered in grease or other material to brake hose (1.1.11 (c))

Rear Tyre slightly damaged/cracking or perishing both sides (5.2.3 (d) (i))

Offside Rear Brake pipe excessively corroded (3.6.B.2c) DANGEROUS

Offside Rear Brake pipe leaking (3.6.A.1) DANGEROUS

Nearside Front brake disc in such a condition that it is seriously weakened (3.5.1i)

Offside Front brake disc in such a condition that it is seriously weakened (3.5.1i)

Offside Rear Registration plate lamp not working (1.1.C.1d)

Inner Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Front Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)