2007 Alfa Romeo 159

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Engine MIL inoperative or indicates a malfunction (8.2.2.2 (g))

Nearside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Rear Parking brake inoperative on one side (1.4.1 (a))

Offside Front Sub-frame corroded and seriously weakened (5.3.3 (b) (i))

Offside Rear Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Nearside Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Engine MIL inoperative or indicates a malfunction (8.2.2.2 (g))

Nearside Front Upper Subframe mounting prescribed area is inadequately repaired welding not continuous and not attached to anything at top below radiator bottom hose (5.3.6 (a) (i))

Offside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Rear Upper Subframe mounting prescribed area excessively corroded significantly reducing structural strength silicone removed leaving corroded hole (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Subframe mounting prescribed area is inadequately repaired not continuous behind bolt head both sides (5.3.6 (a) (i))

dashboard indicates boot lid is open but it is secure

heat shield is loose over center exhaust but cannot come out

rear brake discs outer surfaces scaly

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Suspension arm corroded but not seriously weakened coated with underseal (5.3.3 (b) (i))

Nearside Rear Suspension component mounting repair covered in underseal sill (5.3.6 (a) (i))

Offside Rear Suspension arm corroded but not seriously weakened coated with underseal (5.3.3 (b) (i))

Offside Rear Suspension component mounting repair covered in underseal sill (5.3.6 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Front coil spring broken (2.4.C.1a)

Nearside Inner Rear position lamp(s) not working (1.1.A.3b)

Inner rear brake binding (3.7.B.1)

Nearside Rear Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Offside Front coil spring incomplete (2.4.C.1a)

Offside Rear Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

front tyres worn on the inside edges

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

o/s/f tyre has a cut in excess of 25mm but not deep enough to reach the ply or chords