2007 Peugeot 107

Brake performance unable to be tested (1.2.1 (g))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Exhaust emits excessive dense blue smoke during acceleration (8.2.1.2 (g))

Exhaust hydrocarbon content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength at axle mounting point (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner arch area (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Nearside Rear Wheel bearing rough when rotated (5.1.3 (b) (i))

Offside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Rear Brake pipe excessively corroded (1.1.11 (c))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength at axle mounting point (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner arch area (5.3.6 (a) (i))

Rear Registration plate lamp inoperative in the case of a single lamp or all lamps both rear (4.7.1 (b) (ii))

Offside Rear Brake pipe leaking on a hydraulic braking system (1.1.11 (b) (ii)) DANGEROUS

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement bushes perished, both sides (5.3.4 (a) (i))

Front Windscreen wiper blade defective (3.4 (b) (i))

Rear Brake pipe corroded, covered in grease or other material both rear brake pipes (1.1.11 (c))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Nearside Rear Stop lamp not working (1.2.1b)

Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Rear Stop lamp not working (1.2.1b)

Nearside Rear Stop lamp not working (1.2.1b)

Offside Rear Stop lamp not working (1.2.1b)

Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)