2003 Fiat Ducato

Front Power steering pipe/hose slightly corroded (2.1.5 (g) (i))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Nearside Rear Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Front Power steering pipe/hose slightly corroded (2.1.5 (g) (i))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Offside Front Inner Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Inner Subframe mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Front Shock absorbers has a serious fluid leak (5.3.2 (b))

Offside Front Inner Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Inner wheel arch in several places

Suspension arm ball joint dust cover severely deteriorated n/s and o/s front (5.3.4 (b) (i))

rear suspension quite rusty

surface corrosion to suspension components and non load bearing structure

Windscreen washer not working (3.5 (a))

surface corrosion to suspension components and non load bearing structure

surface corrosion to suspension components

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill under step (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill under step (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength main chassis section (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength strut top mounting area (5.3.6 (a) (i))

bad general surface corrosion to structure ,chassis and suspension components

chassis sections and suspension components have surface corrosion

Brake performance not tested due to seized brakes (1.2.1 (g))

Brakes imbalanced across an axle rear near side low effort (1.2.1 (b) (i))

Front Service brake excessively binding both sides (1.2.1 (f))

Power steering pipe/hose excessively corroded (2.1.5 (g) (i))

Power steering pipe/hose leaking (2.1.5 (a))

Brakes imbalanced across an axle by more than 50% (1.2.1 (b) (ii)) DANGEROUS

Brake hose has slight corrosion to ferrule all front flexible pipes (1.1.12 (f) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Headlamp lens slightly defective both sides faded (4.1.1 (b) (i))

Integral body structure is corroded but structural rigidity is not significantly reduced chassis and cross members have bad surface corrosion (6.1.1 (c) (i))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Suspension component mounting prescribed area is corroded but not considered excessive suspension mounting points and components have bad surface corrosion (5.3.6 (a) (i))

Towbar component corroded, but not excessively tow ball not fitted at time of test (6.1.6 (a))

Nearside Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Headlamp lens slightly defective (4.1.1 (b) (i))

Suspension and chassis corroded

Tow ball not fitted

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

All position lamps light intensity significantly reduced not working (4.2.3 (a) (ii))

Electrical wiring insulation so damaged or deteriorated it is likely to cause a short-circuit Trailer wiring (4.11 (c) (ii))

Nearside Rear Shock absorbers has a serious fluid leak (5.3.2 (b))

Registration plate lamp does not illuminate simultaneously with the position lamps (4.7.2 (a))

Offside Front Brake prescribed area is excessively corroded and functionality of the braking system is affected (1.1.21 (e) (ii)) DANGEROUS

Stop lamp(s) all not working (4.3.1 (a) (iii)) DANGEROUS

Nearside Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Front Brake pipe inadequately clipped or supported (1.1.11 (d) (i))

Offside Headlamp lens slightly defective (4.1.1 (b) (i))

Tow ball not fitted

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Rear Tyre heavily perished but no cords exposed

chassis and suspension components corroded

Items removed from driver's view prior to test ()

Nearside Rear Tyre perished

under body heavily corroded

Nearside Rear rear brake binding (3.7.B.1)

Offside Rear rear brake binding (3.7.B.1)

Nearside Rear Tyre perished

Items removed from driver's view prior to test ()

under body heavily corroded

Brakes imbalanced across an axle (3.7.B.5b)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear rear brake binding (3.7.B.1)

rear brake application uneven (3.7.B.2)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Non obligatory mirror damaged

O/S rear tyre side wall cracking

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Fuel system component leaking (7.2.3)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Non obligatory mirror damaged

O/S rear tyre side wall cracking

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Exhaust has part of the system slightly deteriorated (7.1.1a)

o/s/r tyre perished

Nearside Rear rear brake binding (3.7.B.1)

Offside Rear rear brake binding (3.7.B.1)

Nearside Rear rear brake binding (3.7.B.1)

Offside Rear rear brake binding (3.7.B.1)

pressure pipe from turbine insecure

clearance of bump stop border line