2000 Ford Fiesta

both front tyres worn on inner edges

off side outer sill weak

Nearside Front Outer Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear rear parking brake recording little or no effort not working at all (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Suspension component mounting prescribed area is excessively corroded near side rear inner and outer sill corroderd (2.4.A.3)

both front tyres worn on inner edges

off side outer sill weak

Centre Seat belt anchorage prescribed area is excessively corroded outer sill (5.2.6)

Front Windscreen has a sticker or other obstruction encroaching by more than 10mm within zone 'A' (8.3.1b)

Front Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone 'A' (8.3.1e)

Nearside Front Electrical wiring insecure (1.9.2a)

Offside Front Electrical wiring damaged and bare wires exposed (1.9.2c)

Offside Front Lower Suspension arm ball joint dust cover insecure so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Front Outer Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Rear Brake pipe inadequately clipped (3.6.B.1)

Offside Rear Seat belt anchorage prescribed area is excessively corroded outer sill (5.2.6)

Rear Tyre(s) incorrect because different size tyres are fitted on the same axle. (4.1.A.1a)

Supplementary Restraint System warning lamp indicates a fault (5.4.2)

Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Rear Sub-frame rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

both sides rear wheel arches corroded

slight cracks on osr tyre wall

Brake pipe excessively corroded (3.6.B.2c)

Exhaust emissions hydrocarbon content after 2nd fast idle excessive (7.3.D.3)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Parking brake lever has no reserve travel (3.1.6b)

Windscreen wiper does not clear the windscreen effectively (8.2.2)

Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Rear Sub-frame rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

both sides rear wheel arches corroded

slight cracks on osr tyre wall

Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Front Brake pipe slightly corroded (3.6.B.2c)

Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Rear Sub-frame rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

nsf tyre wearing on edges

Parking brake lever has no reserve travel (3.1.6b)

rear brake application uneven (3.7.B.2)

Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Front Brake pipe slightly corroded (3.6.B.2c)

Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Rear Sub-frame rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

nsf tyre wearing on edges

Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nail in nearside rear tyre

Nearside Windscreen washer provides insufficient washer liquid (8.2.3)

Parking brake lever has no reserve travel (3.1.6b)

Rear Macpherson strut has excessive movement in the upper support bearing assembly (2.5.B.1b)

Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nail in nearside rear tyre

Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear Trailing arm has slight play in a pin/bush (2.4.G.2)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Trailing arm has slight play in a pin/bush (2.4.G.2)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Has moderate wear in rear axle mounting bushes.

Service brake: efficiency below requirements (3.7.B.7)