2000 Ford Ka

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Headlamp aim too low (1.8)

Nearside Rear Suspension arm has excessive play in a pin/bush (2.4.G.2)

Offside Front Front position lamp(s) not working (1.1.A.3b)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Front Macpherson strut has excessive movement at the upper attachment (2.5.A.1c) DANGEROUS

Front Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone 'A' (8.3.1e)

Offside Front Driver's seat insecure (6.2.A.1)

Offside Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Front Macpherson strut has slight movement at the upper attachment (2.5.A.1c)

Nearside Rear Trailing arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Trailing arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Centre Rear Exhaust has part of the system excessively deteriorated (7.1.1a)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Horn not working (1.6.2a)

Nearside Front Tyre has ply or cords exposed (4.1.D.1b)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside Front Tyre has a lump, caused by separation or partial failure of its structure (4.1.D.1b)

Offside Front Windscreen wiper blade insecure (8.2.2)

Offside Inner Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Outer Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Rear Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear Macpherson strut has slight movement at the upper attachment (2.5.A.1c)

Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

Nearside Front Suspension arm rubber bush bonding deteriorated resulting in excessive movement (2.4.G.2)

Nearside Front position lamp(s) not working (1.1.A.3b)

Offside Front Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Rear coil spring fractured (2.4.C.1a)

Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Macpherson strut has slight movement at the upper attachment (2.5.A.1c)

Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Headlamp not working on dipped beam (1.7.5a)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)