1999 Mazda MX-5

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Inner Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Rear suspension arms and subframe showing sines of corrosion

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Nearside Front Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength neat anti roll bar brackets (5.3.6 (a) (i))

Nearside Rear Outer Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Front Brake pipe excessively corroded (1.1.11 (c))

Offside Front Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength near anti roll bar brackets (5.3.6 (a) (i))

Offside Rear Inner Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Rear Exhaust emissions likely to be affected by an exhaust leak center to rear clamp leaking (8.2.2.1 (b))

Rear Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Front Inner Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Rear suspension arms and subframe showing sines of corrosion

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

corrosion under vehicle

Nearside Rear coil spring broken (2.4.C.1a)

Offside Rear coil spring broken (2.4.C.1a)

Parking brake lever has no reserve travel (3.1.6b)

under body and various suspension parts corroded

Offside Headlamp not working on main beam (1.7.5a)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Registration plate lamp not working (1.1.C.1d)

under body and various suspension parts corroded

Nearside Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)

Offside Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)

exhaust system in poor condition

general underbody and suspension very rusty

Nearside Rear Braking system leaking (3.6.A.1)

Offside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

exhaust system in poor condition

general underbody and suspension very rusty

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Front coil spring broken (2.4.C.1a)

Offside Headlamp not working on main beam (1.7.5a)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Service brake: efficiency below requirements (3.7.B.7)

Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Brake pipe leaking (3.6.A.1) DANGEROUS

both front inner wings/chassis legs corroded

under body and suspension components corroded

Exhaust has part of the system slightly deteriorated (7.1.1a)

Nearside Rear Road wheel with a slightly distorted bead rim (4.2.A.1a)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Brake pad(s) wearing thin (3.5.1g)

Offside Front Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Front tyre wearing on outer edge

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)