2000 Ford Mondeo

Brakes imbalanced across an axle (3.7.B.5b)

Nearside Front Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Offside Rear Body has a sharp edge caused by corrosion (6.1.C.1)

Offside Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Windscreen washer provides insufficient washer liquid (8.2.3)

Washer jet to o/s inoperative @ outer

Brake lever has abnormal movement of levers indicating maladjustment (3.5.1f)

Nearside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Front coil spring fractured (2.4.C.1a)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Washer jet to o/s inoperative @ outer

Front tyres wearing on both outer edges.

Handbrake reading to o/s a little low for a vehicle of this type.

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Some movement detected @ handbrake, suspect floor fixing. However, holds ok.

Nearside Front Direction indicators incorrect colour (1.4.A.2f)

Offside Front Lower Front suspension has a suspension lower ball joint securing nut not locked (2.5.B.1a)

rear brake application uneven (3.7.B.2)

Front tyres wearing on both outer edges.

Some movement detected @ handbrake, suspect floor fixing. However, holds ok.

Nearside Front Anti-roll bar rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Nearside Rear Body has a sharp edge caused by damage (6.1.C.1)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Anti-roll bar rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Front Body has a sharp edge caused by damage (6.1.C.1)

Offside Headlamp aim too low (1.8)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Nearside Front suspension has slight movement at a wishbone pin or bush (2.5.A.1c)

Nearside Rear Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front suspension has slight movement at a wishbone pin or bush (2.5.A.1c)

Offside Rear Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)