2000 Rover 416

Body has slight corrosion (6.1.B.2)

Nearside Front Front constant velocity joint gaiter damaged, but preventing the ingress of dirt (2.5.C.1a)

Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front constant velocity joint gaiter damaged, but preventing the ingress of dirt (2.5.C.1a)

Radius arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Oil leak

Rear Direction indicator slightly discoloured (1.4.A.2f)

park brake travel high

Exhaust noise is clearly in excess of that emitted by a similar vehicle fitted with a standard silencer in average condition (7.1.4)

Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Front position lamp(s) not working (1.1.A.3b)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Rear Exhaust has part of the system excessively deteriorated (7.1.1a)

Oil leak

Rear Direction indicator slightly discoloured (1.4.A.2f)

park brake travel high

Front Brake pad(s) wearing thin (3.5.1g)

Oil leak

Rear Direction indicator slightly discoloured (1.4.A.2f)

Nearside Rear Stop lamp not working (1.2.1b)

Offside Front constant velocity joint gaiter split (2.5.C.1a)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Front Brake pad(s) wearing thin (3.5.1g)

Oil leak

Rear Direction indicator slightly discoloured (1.4.A.2f)

Rear Direction indicator slightly discoloured (1.4.A.2f)

Advise,gearbox oil leak.

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)